Head gasket for o-rings

TYTILIDIE

METH HEAD
Searched about this but found nothing. I have a set of vortecs that came o-ringed. Initially I was going to get some SCE's they recommended since my block is not set up for it. Well now it turns out, I am buying the block they came off of. So essentially I really just need to know what type of head gasket I need to get. Any ideas here?
 

ghettosled

SYTY SUPERSTORE
Re: Head gasket for o-rings

Usually the block gets o-ringed and the heads are receiver grooved. Check the depth of the o-ring and if possible, surface them and use cometics. If not feasible, use the Flatout rubber coated copper gaskets ..
 

TYTILIDIE

METH HEAD
Re: Head gasket for o-rings

Usually the block gets o-ringed and the heads are receiver grooved. Check the depth of the o-ring and if possible, surface them and use cometics. If not feasible, use the Flatout rubber coated copper gaskets ..

Are these the ones SCE sells with the silicon water jacket ports? If not, where will I be getting these?
 
Re: Head gasket for o-rings

I run o-ringed heads with cometic MLS gaskets and no receiver grooves in the block. Seems to work pretty well.

Why do you want to run o-ringed heads? Are you having a problem lifting them or pushing coolant?
 

TYTILIDIE

METH HEAD
Re: Head gasket for o-rings

Why do you want to run o-ringed heads? Are you having a problem lifting them or pushing coolant?

No, the heads I bought last year came o-ringed. I am now buying the short block they came off of. The machine shop said I would be better off getting a special gasket for it or something. I had that conversation three months ago and I forgot what all they said.
 
Re: Head gasket for o-rings

Yeah, o-rings really aren't typically needed for these engines like they are for Gen III/IV V8's and the Buick V6's due to them lacking a head bolt per cyliner. Unless you're going to be running crazy boost though. :D
 
Top