HELP! Mad some mods, now need help!

alllottofun

New member
Guys & Gals, to be politically correct... I just added a 3bar map sensor, 3bar chip and a Bad Dog 20G 475hp Part # 49179-04100 Direct bolt in
for '92 GMC Typhoon. The 3bar chip has like 24 different program sellections and I haven't a clue as to which one to choose. My MAIN issue is that I do not know how to make this new turbo spool up quicker. Any ideas?

1992 Ty
under pulleys
high stall convertor
air foil
KB cold air kit
stock injectors
Summit high flow cat
Cherry Bomb straight thru muffer
 

Sy769

Donating Member
Which version of the chip do you have? Look on the eprom and there should be a number.

Program layout for stock injector:

Security
Valet
Three levels of timing followed by the boost setting. Example T1 15 is the lowest timing setting with 15 lb. boost setting. T115 is the only progam with EGR enabled so you should use it for emmisions testing.
T1 is pump gas
T2 is strip/street setting depending on truck octane available
T3 strip only with race gas or water/alky injection

Boost control on the stock injector ultimate is for a stock turbo so the 16 lb. setting on the chip may or may not yield 16 lbs.
 

Eluding

New member
In my opinion the Bad Dog 14cm exhaust housing is way to big for Colorado. You're going to have a hell of a time getting to spool with anything less than a 3400 stall converter. And 3400 is pretty miserable to drive on the street. Did you buy it Turbo Engineering Corp. ? TEC was trying to sell me that turbo and promised that it would spool EXCELLENT on the STOCK torque converter. :roll:
 
Top