Help My Typhoon (Updated with DM File)

tbauer03

TRBOBOX
My truck wasn't starting for the past few days and was throwing a code 42 so i replaced the ignition module today and everything seemed fine.

After driving it around a few times it was all good but about an hour ago it randomly died going down the road. I tried to start it and it kinda started but just was puttering then it would die. My buddies and i pushed it off the road and in to a parking lot. I started it up and fed it a lil gas but it didn't like it. It was really rough and then it started smoking i don't know where the smoke was coming from and i just left it sitting there. Came back after an hour or so. I Checked the oil and it looked fine I looked around for any big leaks and didn't see anything, started it up and it ran fine, i drove it back to my house just to get it out of the parking lot to avoid a ticket and it was running fine. I got to my parking lot, and put in reverse to park it and then it died and then it started doing the same thing just puttering and smoking. The distance from the parking lot to my house was only about a mile btw.

Any thoughts on this one?
 

odium

1BADGMC
Ignition woes. Take the cap off, check it, replace cap and rotor if needed, and reseat it to make certain it's on straight. Maybe even try an old cap if you have one. I've thrown a 42 when my cap wasn't seated quite right and it was doing things similar to yours, but it wasn't dying.

Do the usual, check for fouled plugs, check the resistance of the wires (~.8 to #1, ~.6 to the other five, and ~.18 for the coil to dist, give or take .1 ohm.

EDIT: You might want to check and make sure you plugged the tan wire back in, too. Sometimes it gets kicked and unclips.

Posting a datamaster file would help out, too.
 

tbauer03

TRBOBOX
yeah i used the white stuff that came with it. Should i pull it back off and use the clear dielectric grease?
 

SY2932

Administrator
odiwik said:
EDIT: You might want to check and make sure you plugged the tan wire back in, too. Sometimes it gets kicked and unclips.

Ditto, that would be the first thing I would check too...
IMG_0569.sized.jpg

"The "tan wire with a black stripe" that everyone can't find when attempting to set their timing. Wire is under the carpet on the passenger side below the heater box. It is disconnected to set the timing, then reconnected."
 

ItsMyTy

Life is beter at 25 PSI
just a thought whenever you're getting some weird problems, weird combos of codes being set, it might be a wiring harness problem

my truck's main engine harness is screwed up right next to the downpipe. if i wiggle it, the IAC will stop working, injectors will stick on any time the key is on, sets random other codes.

i've gotta run some new wires. probably going to run all new wires away from the downpipe and get rid of that 90 degree bend that the factory grommet does to the harness.
 
Top