High revs at idle

robberttyphoon

New member
Have replaced MAP-sensor, spool in ignation and any sensor we could find. But the Ty won't run properly. As I turn the ignition on, the pump under the radiator starts turning en "check engine" keeps burning after starting.
I noticed a small sensor-piece with vacuum lines between the turbo in-outlet and there are open exits. Could this have someting to do with my problem.
Before the car would run great for about 20 min. before "check engine" would spoil the fun and put the engine in "safety-mode".:(
Please help, am in Europe, not much knowledge around here. It's a stock '92 Ty with intercooler that ran fine for the first 6 months or so, have had it for 3 years.
Thanx!
 

nonova0074

Member
Re: High revs at idle

That sensor controls the boost, as you turn the ing on the noise you hear is your intercooler pump. I would replace the vac lines, contact sport machines for the kit. What code is the check engine light setting off?
 

bundie

New member
Re: High revs at idle

welkom robert,
Amsterdam is niet zo ver weg haha,

I woould check your vacuum lines for leaks
 

robberttyphoon

New member
Re: High revs at idle

It's idling at 2,3-3k rpms and lowers when you rev it hard a several times, goning down to 1,5-2k rpms.
I noticed that the pump is for teh intercooler. The check engine light did give codes in the past, but now is doesn't anymore, just lights up constantly.
We are going to set the timing with Bezerk's advice and check all vacuum lines.
Thanx!
 

Quickstop [UK]

Combating adversyty.
Re: High revs at idle

Engine light is on because there is a code.

Plug the ALDL and get the code from it.

Remove and replace the ECM B fuse to clear codes. start it and see if the code reappears.

IAC may be dead...

See you in October!
 
Top