GREperformance
New member
Hello everyone,
I own a shop up here in Lancaster, Ca. and took on a project to build a customers 92' typhoon. Let me tell you this thing has been a nightmare; but anyhow let me cut to the chase. We have the truck finished now. We went through the motor, rebuilt it with forged components and ARP hardware, SCE Titan Headgaskets, a Bullseye Power 60-1 Turbo, 3" stainles mandrel bent exhaust, HUGE front mount intercooler, it has a .510 lift extreme energy comp cams, new rearend, a fully built Mike's Trans 700R4 with a 10" stall converter. Anyhow the list goes on and on. Now to the problem; we purchased a Perfect Power (PP) piggy-back system for fuel control because we were led to believe it was the best thing out there since chips are hard to come by it seems now. We decided to leave the stock fuel injectors and use the Injector drivers the PP has to drive two 650cc low impedence injectors for supplimental fuel under boost. This seemed like the ultimate solution, drives like stock around town and plenty of fuel capability up top for driving hard. Well we have been fighting this thing for a month now and cannot get this thing to perform as advertised as well as the interface feels like it was programmed on an apple IIE in 1986! So, I have tried to contact SyTychips.com with no luck, and I cannot seem to find anyone with a 3bar 50# injector solution. Can anyone lead us in the right direction? Thanks for the help in advance!
I own a shop up here in Lancaster, Ca. and took on a project to build a customers 92' typhoon. Let me tell you this thing has been a nightmare; but anyhow let me cut to the chase. We have the truck finished now. We went through the motor, rebuilt it with forged components and ARP hardware, SCE Titan Headgaskets, a Bullseye Power 60-1 Turbo, 3" stainles mandrel bent exhaust, HUGE front mount intercooler, it has a .510 lift extreme energy comp cams, new rearend, a fully built Mike's Trans 700R4 with a 10" stall converter. Anyhow the list goes on and on. Now to the problem; we purchased a Perfect Power (PP) piggy-back system for fuel control because we were led to believe it was the best thing out there since chips are hard to come by it seems now. We decided to leave the stock fuel injectors and use the Injector drivers the PP has to drive two 650cc low impedence injectors for supplimental fuel under boost. This seemed like the ultimate solution, drives like stock around town and plenty of fuel capability up top for driving hard. Well we have been fighting this thing for a month now and cannot get this thing to perform as advertised as well as the interface feels like it was programmed on an apple IIE in 1986! So, I have tried to contact SyTychips.com with no luck, and I cannot seem to find anyone with a 3bar 50# injector solution. Can anyone lead us in the right direction? Thanks for the help in advance!
Last edited: