I need help with my ultimate!

Turbo6

10.20@131.8
Well it would have to be leaking injectors.....thats the only path for fuel to get into the cyls. I dont think they would all leak the same or similar but who knows.
 

Turbo6

10.20@131.8
The fuel pressure acts normal so I have not check that but I will take a look tonight. Thanks!
 

Turbo6

10.20@131.8
The smoking probem is fixed. I installed felpro #727211 (I think thats the #) positive seals on the exhaust valve stems. It must have some wear on the guides and was letting too much oil by. The truck is still very rich in open loop so I can just drive around with it in valet mode and its perfect.
 

smeagol

Active member
You have some sort of problem unrelated to the fuel programming. It is NOT calibrated too rich in open loop mode unless there is something you have drastically different than most bolt on trucks. There WILL be variance between trucks, but nothing that will affect it that much. If you are fouling plugs, and running horribly rich, it is not a calibration problem. These programs are proven many times over in stock motor trucks.

Give us an update... do you still foul plugs? is the drivability piss poor in the regular programs? What are the INT/BLM readings in the closed loop programs? What AFR's are you seeing at WOT ?
 

Turbo6

10.20@131.8
Nothing different than most other trucks. I took it for a test drive last night and was getting 11.9/1 AF ratio at WOT on T2 17 ( 45# base FP at 18 psi.) getting 1deg of retard max. on pump gas. It does have 1.6 rockers and headers. Some of the black on the plugs may have been a little oil. I will pull a couple of them out tomorrow and look at them. I will look at the closed loop log and see what it is doing also.

Thanks for your help.
 

Turbo6

10.20@131.8
I have not had a chance to do anymore testing. I decided to put the stock fan back on (had to gather up parts). The black magic fan will NOT keep the truck very cool with the A/C on in traffic. To make this work I had to redo the IC piping all to the passenger side. I have the McCoy setup. I had to take the IC off to get to things and took a look inside of it. It had a thick oily film in it like a turbo had puked oil in it at some point. The pipes did not have the oil just the IC. The IC also had a shop rag in it! I had to fish it out with a wire. It was blocking off about 10% of the IC core. I took it to a radiator shop to have it clean out and they also found a hole where the core is welded to the tank. They welded it back up no problem. One day I will find all the bugs in this thing maybe.
 

smeagol

Active member
Ya need to let Caleb/McCoy know about the cooling issue, so he can resolve that. Caleb is a fanatic about that stuff and should help out.
 
Top