Inconsistent Boost at WOT

tbauer03

TRBOBOX
Ok i got my truck running really well right now using a 3 bar chip and fp set at 45. I did a 1/4 mile run at 13.6 according to g tech with 0 knock the whole time. The only thing is my boost was very inconsistent throughout 1st and 2nd gear it started to level out at about 16 psi in 3rd.

In first gear it started about 10lbs then went up to 13.4 then shifted and i got a brief spike to 14.6 then down to 10.9 about 1/2 way through 2nd then by the end of 2nd it climbed to 15.5 i got another brief spike to 17.1 on the shift but then it fell down to 11.1 then it climbed and held steady around 16 psi the rest of the run.

I am running pretty rich about 990-1010 02mv throughout the run and that may have something to do with it but i am thinking it is the stockwaste gate. I am pretty sure an external wastegate should correct this and make my boost less like a rollercoaster. But i was really wondering if there were anyother solutions for this problem to try before i do an external wastegate.
 

Captain Morgan

Moderated User
if your using the stock solenoid, thats your problem right there.


an aftermarket boost controller, even a manual bleeder will solve that problem.

I have solid boost with the ATR manual bleeder on my truck, unfortunately the boost builds slow ass hell with it, so its not on my high recommendation list, but it works for now.

either way, thats most likely the problem. HTH
 

dgoodhue

BuSTeD 4.3
Re: Inconsistent Boost at WOT

tbauer03 said:
Ok i got my truck running really well right now using a 3 bar chip and fp set at 45. I did a 1/4 mile run at 13.6 according to g tech with 0 knock the whole time. The only thing is my boost was very inconsistent throughout 1st and 2nd gear it started to level out at about 16 psi in 3rd.

In first gear it started about 10lbs then went up to 13.4 then shifted and i got a brief spike to 14.6 then down to 10.9 about 1/2 way through 2nd then by the end of 2nd it climbed to 15.5 i got another brief spike to 17.1 on the shift but then it fell down to 11.1 then it climbed and held steady around 16 psi the rest of the run.

The stock boost control is like a roller coaster, but you can make it better. I assume you have an ultimate chip, right. Mine acted like yours. I adjusted my wastegate rod to make it shorter (I trhink I ended up with 3 turns, but every truck will be different). I also added a spring so that my base boost was higher (stock is around 9-10psi) My truck now jumps upto to 12-13 and then climbs higher.
 

leroy

Donating Member
Ted,

I agree with Dave about adding a spring. The closer the spring pressure is to the boost you want to run, the better. Just go to the hardware store and pick out a couple that look like they will fit.

There are some things that can be done with the chip, like lowering the solenoids reaction time, and scaling boost against mph instead of tps.

The best boost control I've seen is with an external wastegate, though.

Jim
 
Top