Injection Timing

MadMike

Member
Does anyone have any info on injection timing? Or like maybe what it is called in the GM bin file?

I can't seem to find much on the topic. I know the idea is not to be injecting thru an open exhaust port but I don't have any idea where that is on a stock cam. I figure I can vary it and just chase a higher vacuum??? but some insight would be helpful. Thanks
 

JSM

Active member
Re: Injection Timing

Only way to inject through an open exhaust port would be to put the injectors on the exhaust side. Never seen that done.

I think you have sequential and batch fire confused. Our trucks spray all 6 injectors at the same time, not timed to anything other than each revolution (sometimes every other revolution).
 

MadMike

Member
Re: Injection Timing

Ya. Im using a batch fire(inject) setup. I was quoting someone else.

Your right maybe I should think of it as timing per revolution and not injection since I'm batching. I guess then even, I will have to think about it more. It might not even matter that much when I'm batching.
 

JSM

Active member
Re: Injection Timing

In a batch fire what would you time it to? #1 cylinder? The rest then are not in sync. So it really doesn't matter when it fires as long as its once per rev (or at low RPM our stock ecm does once every other)
 

Quickstop [UK]

Combating adversyty.
Re: Injection Timing

This batch fire has always puzzled me - surely at least oinbe cylinder is burning/full when the batch goes off....

Doesn't make sense to me.... :dunno:
 

JSM

Active member
Re: Injection Timing

The wiring is actually the left bank and right bank of injectors. When it goes back to ECM they connect internal to ECM to the same driver, hence all 6 fire at same time.

Some injectors fire with intake valve closed and fuel awaits for valve to open up. Granted this is all in milliseconds of timing. If your making 1k hp sequential is the way to go for a bit more power, it has been shown below that level batch does a fairly good job and not a lot to be gained.

Anybody that has seen a Buick Grand National start will probably know it takes a few cranks before it will attempt to fire, as the ecm is looking for the #1 cylinder pulse in order to fire injector, which can take a few revolutions of the motor to sync up.

Our distributor sends 6 pulses to the ECM, keep in mind though the ecm has no clue what pulse is what cylinder you need a crank trigger to determine that which we do not have. The dist cap and firing order is the only thing that knows what cylinder is to fire next, which is all mechanical. Reason you can move wires around on the cap to get it to fire correctly. Can't move wires around on a buick coil pack to do that.
 

MadMike

Member
Re: Injection Timing

Essentially timing doesn't matter in batch/bank injection timing. When you fire 6 or 3 alternating (Bank) you only could time the injection to 1 cyl, or 2 repectively.

I was a little confused on the issue and its relevance.

Here's the article that cleared it up. Sequential vs Bank / Batch vs w/e all at once.

http://www.sdsefi.com/techseq.htm
 
Top