SikVSix
New member
Ok,
so I finally got my DM working today, and one of the 1st things I wanted to look at was the injectors as I thought the stockers may be coming up short. The truck seems to have a built in rev limiter around 4200 rpm ( varies some).
Sure enough the duty cycle is high and keep in mind I've never seen DM files before but how can the DC be over 100%? On a 1/4mi type run, the cycle stayed around 95-120% with a few dips that I couldnt explain unless its just a bad spot in the file or something. also had plenty of spark retard, think it was up to 8 if i remember right, trying to remember too much info here.
So I guess its obvious I need injectors but now I'm wondering if 50's will be enough, or should I go ahead with 75's or something as I plan to add alky soon and heads etc later.
Here's what I have now;
-all stock long block
-PTE 51
-manual valve running around 17psi
-3 bar
-custom chip ? ( all I know is its set up for the 17psi )
-ATR 3" DP- no cat
-K&N to Cobra head pipe
-walbro 255
-AFPR (40 at vacuum, up to about 60 @ full boost)
-stock injectors
-hot wired jasbro ic pump
-2800 stall in a nice tranny
thats most of the important stufff I can think of
I guess another thing I'm wondering is if the injectors are maxed out, why hasnt it leaned out and destroyed some stuff, is the ECM smart enough to keep it from self destructing?
any adivse is appreciated
Sean
so I finally got my DM working today, and one of the 1st things I wanted to look at was the injectors as I thought the stockers may be coming up short. The truck seems to have a built in rev limiter around 4200 rpm ( varies some).
Sure enough the duty cycle is high and keep in mind I've never seen DM files before but how can the DC be over 100%? On a 1/4mi type run, the cycle stayed around 95-120% with a few dips that I couldnt explain unless its just a bad spot in the file or something. also had plenty of spark retard, think it was up to 8 if i remember right, trying to remember too much info here.
So I guess its obvious I need injectors but now I'm wondering if 50's will be enough, or should I go ahead with 75's or something as I plan to add alky soon and heads etc later.
Here's what I have now;
-all stock long block
-PTE 51
-manual valve running around 17psi
-3 bar
-custom chip ? ( all I know is its set up for the 17psi )
-ATR 3" DP- no cat
-K&N to Cobra head pipe
-walbro 255
-AFPR (40 at vacuum, up to about 60 @ full boost)
-stock injectors
-hot wired jasbro ic pump
-2800 stall in a nice tranny
thats most of the important stufff I can think of
I guess another thing I'm wondering is if the injectors are maxed out, why hasnt it leaned out and destroyed some stuff, is the ECM smart enough to keep it from self destructing?
any adivse is appreciated
Sean