Injector???????

kessler

kessler

New member
Ok now i might be a little stupid for asking this, But

Since Mitsubishi Injectors are 450cc in a turbo motor, That would calculate out to 42-43lb injectors right. And our stock injectors are 32lb right?

So would the stock mitsu injectors fit in our trucks.

The reason i ask this is due to some money isues i have decided to cut back on the full build so i wont be needing the Bigger 50lb injectors so i was just going to see if they would work and then take them up to get flow tested to see if there ok

I used this Calculator to figure this out.http://www.witchhunter.com/injectorcalc1.htm
 
Ty0279

Ty0279

Historically Significant
Re: Injector???????

I don't know if they would fit or not, but don't mess around w/ 40lb inj on these trucks...it'll be a tuning nightmare/impossibility for you.

Stick w/ the stockers or go w/ the 50's.
 
E

E-Rue

New member
Re: Injector???????

we sell the mitsu and the domestic injectors, and they are not interchangeable. the eclipse uses a totally different oring pack, and injector diameter where the orings mounts is also different. hope this helps.

e
 
dgoodhue

dgoodhue

BuSTeD 4.3
Re: Injector???????

Honestly you don't want to start just plugging in Fuel injector and thinking they are close enough, our truck are sensitive to fuel because of the map sensor. Injectors are not exactly linear, different injectors vary in linearity, and some aren't very linear at all. I put in the 50# in my Truck and I just did 'math to calculate' what I should scale the ECM to. I could not get the truck to run. I copy the tables from a 50# bin which was quite bit different that what I had and it ran first try.
 
You must log in or register to reply here.
Top