innovative MSBC install question

ed hess

race or get outta the way
doing install for single port wastegate:


schematic at top of page 6 doesnt show the boost sensor location!

Then again 2 of the other schematics do not show the boost sensor either.

Am I correct in assuming they leave this out of the schematic only if it is not tee'd off one of the lines?

I realize the boost sensor must be installed somewhere otherwise the controller has no input signal to controll the outputs to the solenoids!

I assume the best place for the boost sensor is tee'd off the pressure nipple port from the turbo?
or the intake (just like the present map sensor)?

ed
 

Pittman

New member
In the buick I T-ed the line giong to my boost gauge and ran that over to the sensor. Basicaly its up under the dash. Then I ran the line back to the unit in the cener console.

Is that your question?

You using a stock style actuator????
 

ghettosled

SYTY SUPERSTORE
off the top of my head i cant remember the single port wg configuration (will have to look at the instructions) but there is a difference where you hook up the pressure sensors. Some require both pos/neg manifold pressure, and one can be run off the compressor housing. If hooked up wrong, the controller will act up.
 

TURBO TY

New member
how is the innovative boost controler compare to the greddy Profec-E? and which one is better suited for our app?
 

ed hess

race or get outta the way
this post is now a mute point since the wastgateis about to be changed to an external innovative minigate.....

yeahi'l get this all done and find out i had a bad controller or did something stupid...

regardless with the exteranl and an 8 lb spring i can fine tune launches more, as well as being able to ramp the turbo from launch thru 1st gear.

ed

btw i had the boost sensor plumbed to the upper intake which innovative told me was correct.
 

ghettosled

SYTY SUPERSTORE
yeh most likely you had it correct. Either way with the external your boost control will be much better. Now you can tap into your brake lights for the 12v source for the launch setting (when on the brakes it will only make 8psi), then have your DFI trigger the built in 2 step for about 2800 and there you go. Let off the brake, floor it and into stage one you go. Hit another button when you are loosing and get some more boost.
 
Top