innovative WB02 +gauge and patch

bezerk

New member
hello.

coming at the point to connect my LM1 WB02 to the ECM.
here for i have to use the analog output on the LM1.
i purchased an analog gauge for the LM1 also, so i can hide the big ass LM1 and keep an eye at the a2f ratio on the gauge.

the LM1 has 2 analog outputs, and 1 is for the ECM and the other for the gauge.
but do they share the same ground? can i just split the ground to the ECM as well as the gauge?

can both the analog outputs on the LM1 be changed?
the ECM wants 0-5V and the gauge 0-1V?

Thanks for your help
 

KETCH-UP

New member
Re: innovative WB02 +gauge and patch

Assume the wb o2 unit is powered from truck's 12 volt system, then the two outputs will be referenced to the same potential 12 volt neg. You should be able to use either output to feed to the ECM, but are they both 0-1 volt signals? If you want to get the best resolution on the ECM end, you should make a buffer amplifier with a gain of 5 to boost the 1 volt signal. The buffer will also prevent o2 signal loading.
 

bezerk

New member
Re: innovative WB02 +gauge and patch

KETCH-UP said:
Assume the wb o2 unit is powered from truck's 12 volt system, then the two outputs will be referenced to the same potential 12 volt neg. You should be able to use either output to feed to the ECM, but are they both 0-1 volt signals? If you want to get the best resolution on the ECM end, you should make a buffer amplifier with a gain of 5 to boost the 1 volt signal. The buffer will also prevent o2 signal loading.

the ECM wants 0-5V and the gauge 0-1V.

there are 3 wires coming from the ananog output of the LM
1 is ground and the others are for analog 1 and analog 2.
you think it will become a prob. to split the ground?
 

Jimmy

Banned
Re: innovative WB02 +gauge and patch

bezerk said:
you got the same setup, Jimmy?

thanks
I have been researching it and will buy it asap.They even have a forum where you can find out everything you need to know.
 
Last edited:

93 TY 2185

Donating Member
Re: innovative WB02 +gauge and patch

Jimmy said:
I have been researching it and will buy it asap.They even have a forum where you can find out everything you need to know.

Yes the support is why I went with the Innovate product.
Ok.gif
 

bezerk

New member
Re: innovative WB02 +gauge and patch

i just visited the forum... seems like a good product.
thanks for all your help.
 
Top