Intake gaskets & port matching intake.

4C FED

Absolutum Dominium
Does anyone have a manufacturer & PN for the intake gaskets to use with the Vortec heads? I'm looking for the fiber ones, not the plastic.
I'm going to dump the plastic spacers & the 1" high slicone dam's and make some phenolic spacers, so I wanna clean this mess up.

Secondly, when porting the lower intake, Is there enough material to enlarge the intake port all the way to the gasket?

My ports still have room to grow to match the gasket, but it could be to thin.

Mr. Waller, any input would be greatly appreciated.
 

jwaller

Evil Genius/SyTy Guru
there isn't enough room to port the intake to match the vortec head....you must weld it. the gasket is a race felpro...PM me for the number.... you will also need to continue to run a spacer of some sort bc your heads have been drilled that way. and if you try and bolt it on using the no spacers method the intake will not line up. it's about 1/8 in off. you will need to slot the holes on the intake to get them to fit without spacers.
 

4C FED

Absolutum Dominium
Yep, I understand about the spacers.
I'm going to do some phenolic spacers like this:
intake4.jpg

Just need to figure out the right thickness so everything lines up again.

Thanks John.
 
Top