Intake Manifold options (carbed)

libertysyclone

New member
What other options as far as intake manifolds/head combinations are there for our block? will a carbed 4.3 fit vortecs? all the info i could get would be great. Oh yah just incase anyone is wondering I am toying with the Idea of running LPG. injection is almost 100% out, unless anyone knows of a LPG injection system or parts anyway.
 

libertysyclone

New member
Re: Intake Manifold options (carbed)

116 octane, cooler cyl temps, little lower btu's BUT its a 100% gaseous state in the cylinder. $1.30 a gal. all in all I am not looking for a 9 sec truck maybe low 11's but I want low 11's at "any" time. And who else could hook up a grill to their gas tank?? :) A this point its still just an IDEA, I have most of the stuff besides tanks to do it I was just looking in to a manifold.
 

jwaller

Evil Genius/SyTy Guru
Re: Intake Manifold options (carbed)

propane has been tried and it didnt do much of anything for lowering the MAT temps.
 

Don W.

Stab it and steer it
Re: Intake Manifold options (carbed)

libertysyclone said:
116 octane, cooler cyl temps, little lower btu's BUT its a 100% gaseous state in the cylinder. $1.30 a gal. all in all I am not looking for a 9 sec truck maybe low 11's but I want low 11's at "any" time. And who else could hook up a grill to their gas tank??
icon_smile.gif
A this point its still just an IDEA, I have most of the stuff besides tanks to do it I was just looking in to a manifold.
rant3.gif

In my experience, which goes back a number of years, propane does not burn cooler. Also fewer MPG (less BTU per gal). Yur correct, it’s 100% gaseous, even before it gets to the manifold much less the cyl. This means you HAVE to run some sort of vaporizer to make liquid propane into vapor. Special, but available, tank required to supply liquid propane. Unlike your BBQ you can’t get enough vapor from the tank to the engine without the tank freezing up. The more you pull from the tank the colder it gets. The colder it gets the less vapor you get. Sort of a downward spiral. Vaporizers use engine heat (coolant water) to “heat” the liquid propane and turn it into vapor which is supplied to the engine. A plumbing nightmare in a SyTy. I could be wrong but I seem to remember 1 gal of pro turns into 33 gals of vapor so you can see that the plumbing from tank to engine, if vapor only, would be prohibitive. An interesting sidebar is that the engine runs CLEAN. No sludge, almost no varnish, no crud, no nothin'. Take a 10 year, 150,000 mile propane engine apart and it looks like it went together yesterday. Almost unbelievable untill you see one.
rant3.gif




My last propane experience was more than 20 years ago but I think I’m close.

Cheers
icon_biggrin.gif
 

ghettosled

SYTY SUPERSTORE
Re: Intake Manifold options (carbed)

figure out what heads you want to use, then there are several manifold choices which will work or can be made to work.. Pretty much all the heads will bolt to the block, but many require different headers, or raised runner intake manifolds.

edlebrock makes a carb manifold for vortec cylinder heads and we have converted several to efi..
 
Top