Is my ECM dead???

jamnut

Member
So I've been working on my truck for a few weeks. Thought that I was done & went to start it, the battery was low so I hooked it up to jumper cables & hooked them up backward. The cables started smoking immideatly. Now my truck doesn't want to start & the display for my Ultimate isn't working.


So did I mess up my ECM, ultimate, both or could it be something different?
 

skwayb

NWSTP
Re: Is my ECM dead???

Hmmm. Could be. Not sure if this would help but I would check Fuses ECM A and ECM B. Replace any blown fuses. Also try disconnecting the battery for a couple of minutes to let the ecm reset. I think there is a fuseable link also to check. I can't remember because mine has been stock for 10 years.....If those things don't work I think you ecm could be damage especially since the ultimate is displaying some strange things on its display.
 

alwayscode390

pppssssshhhhhtttttttttttt
Re: Is my ECM dead???

My mom did the same thing on her Ford Taurus ( yeah I know not the same as your SY ) , but she fried the entire ECM , and the car was essentially trash after that because it was an old Taurus, lol. Good luck ---
 

willyson

trollin'
Re: Is my ECM dead???

Odds are your battery and fuses are shot. Hopefully you didnt hold the cables on there long enough to do a lot of damage, but its still possible. Check those and go from there.
 
Top