Kenne Bell chip

bjzq8

New member
KaBoom

KaBoom

I would imagine if your truck hasn't exploded yet, it's NOT a Kenne Bell chip. :lol:
Other than that...I would imagine it has something on the PROM itself. I used to have an ATR Pitbull chip, and it was marked right on the PROM.

Bill Jenkins
1992 Typhoon #1752
 

Sy769

Donating Member
Pull the ECM and see if the chip has any writing on it. If it is a blue memcal that has not been cut on and the Eprom is still soldered in place then it is a stock chip most likely.
You definitley need to verify this as some of the KB chips had timing retard disabled which is why they earned the bad name. (That and the calibration sucks I hear.)
 

jwaller

Evil Genius/SyTy Guru
do you have access to a scan tool or datamaster? if so you can test the chips ability to retard knock by lightly tapping on the motor with a hammer with KOEOff. and the prom ID could also be helpful.
 
Well here is the deal I have a knock and I tried the timing light trick and the noise seems to be at 350 rpm and out of rythem with the light. Also tried grounding the plug wires (to kill cylinder). Knock never changed. Smokes a little at start-up. Someone on the board suggested that I might have a kenne bell chip in the truck so I want to make sure. He said that his truck had the same symptoms and that was his problem. It has had a 3 inch Borla exhaust since I bought it so I want to make sure he didn't put in a kenne bell.
 

leroy

Donating Member
little black psycho said:
Well here is the deal I have a knock and I tried the timing light trick and the noise seems to be at 350 rpm and out of rythem with the light. Also tried grounding the plug wires (to kill cylinder). Knock never changed. Smokes a little at start-up. Someone on the board suggested that I might have a kenne bell chip in the truck so I want to make sure. He said that his truck had the same symptoms and that was his problem. It has had a 3 inch Borla exhaust since I bought it so I want to make sure he didn't put in a kenne bell.

Do you mean 3500 rpm?

Check closely for an exhaust leak. They can make a nasty sounding knock, and can be repaired easily. Probe around with a stethoscope, or hose to your ear to pinpoint the location.

Good luck.

Jim
 
The truck idles at around 700 rpm and the noise is about half of that. The noise gets quieter when you rev it and just about goes away around 1500 rpms. I also live in Phoenix Arizona.
 

bjzq8

New member
Shootout

Shootout

I imagine that the only thing shooting out would be your rods...through the side of the block.
 
Top