Ok, I need some help here. My truck acts funny when I go into boost. Runs great for normal driving but the minute I hit the accelerator the truck acts like it is at a lack of fuel or something. I ran datamaster and recorded some runs. What is funny is that in all of the runs it shows my o2 mv's dropping down when getting on the gas, its drops as low as .100 mv
Below are some datamaster files.
This is with either the stock chip or the ATR Pitbull, can't remember
http://mywebpages.comcast.net/timgt/timstruck2.uni
This is after switching to a 3-bar chip
http://mywebpages.comcast.net/timgt/timstruck3bar.uni
I then tried swapping in a walbro fuel pump thinking that was the problem, here is after the walbro
http://mywebpages.comcast.net/timgt/timwalbro.uni
And Finally I went back to the ATR pitbull chip after zeroing out my timing that I realized was advanced 8 degrees
http://mywebpages.comcast.net/timgt/timback2pitbull.uni
Any ideas would be great, im soooo lost as to what to try now. Im sure this truck could use a replacement of all vaccum lines and new plugs and wires (changed the cap and rotor last night and that didn't help)
Below are some datamaster files.
This is with either the stock chip or the ATR Pitbull, can't remember
http://mywebpages.comcast.net/timgt/timstruck2.uni
This is after switching to a 3-bar chip
http://mywebpages.comcast.net/timgt/timstruck3bar.uni
I then tried swapping in a walbro fuel pump thinking that was the problem, here is after the walbro
http://mywebpages.comcast.net/timgt/timwalbro.uni
And Finally I went back to the ATR pitbull chip after zeroing out my timing that I realized was advanced 8 degrees
http://mywebpages.comcast.net/timgt/timback2pitbull.uni
Any ideas would be great, im soooo lost as to what to try now. Im sure this truck could use a replacement of all vaccum lines and new plugs and wires (changed the cap and rotor last night and that didn't help)