Knocking

Quickstop [UK]

Combating adversyty.
Hi,

just got a stock 93 Typhoon from my Dad. It has a couple of problems specifically knocking and the wastegate (other thread).

Where can I read up on the casues of knocking in this car (usually only at full power at around 160kph - accelerating).

I want to get some diagnostics kit. Can someone give me a list of things I should buy and perhaps some suggestions of where to get it.

My background is that of an electronics engineer so once I have it I'll be ok. Never messed around much with engines is all.

Thanks for your help.

Q
 

VermontTy

Support Our Troops
Re: Knocking

Knock's a big topic here.....Its caused by the fuel-air mixture igniting because of the heat caused by compression instead of the spark plug igniting the mixture. Reasons for this happening vary GREATLY. Gasoline with lower octane levels, running too much boost for the fuel you're running, running too much timing, carbon buildup in the manifold, bad spark plugs, the wrong gap in a spark plug, a low-powered ignition system, bad cap & rotor, weak intercooler pumps, low intercooler coolant levels, heat soaked air intake and intercooler systems, the inherent knock-prone combustion chamber design on the stock LB4 and L35 heads, false knock caused by anything from noisy aftermarket valvetrain to rattling heat shields, fuel lines and loose parts. Guys have chased knock problems through years and lots of new parts, and never really found a reason....if you search the board for knock causes and what not, you'll find a helluva lot of info....

EDIT

Here's a little reading I quickly scrounged up.....

http://www.syty.net/forums/showthread.php?t=30336
http://www.syty.net/forums/showthread.php?t=565
http://www.syty.net/forums/showthread.php?t=33151
http://www.syty.net/forums/showthread.php?t=30373
http://www.syty.net/forums/showthread.php?t=3118
 
Last edited:

AUSyTyIN

Unbusted $#it box
Re: Knocking

Best bet is to find a local experienced truck owner with datamaster. Where you located? UK? (bugger, KPH)
 

Quickstop [UK]

Combating adversyty.
Re: Knocking

No such thing here as a local experienced truck owner with datamaster.

Is datamaster the scan tool?

What I am planning on doing is replacing the fuel filter, putting new spark plugs in, checking the fuel pressure and consider putting in an AFPR (is that right - have read people use them).

I have a lot to read up on with this truck but I love it..shame about the fuel ecomonomy - $7 per gallon :((
 

AUSyTyIN

Unbusted $#it box
Re: Knocking

Datamaster is program that allows you to plug in a laptop into your truck (via a cable that you also need). It shows you all of the engine conditions that your ECU sees.

Where you located? We have SyTy'ers just about everywhere
 

Quickstop [UK]

Combating adversyty.
Re: Knocking

I am located in the UK, near Ipswich. If there is anyone nearby then I would love to swap stories/advice.

Is datamaster any good? i hear a lot of people using it on here. Can I reprogram anything using datamaster?

I think I will get some new plugs, and try and boost the fuel pressure. I think I have the stock rotor and coil so will need to get them replaced as they are original on a 60k miles vehicle.

This advice is like gold dust. Keep it coming! Thanks!
 

AUSyTyIN

Unbusted $#it box
Re: Knocking

Datamaster is awesome. There is no reprogramming through it, just knowing what is going on inside your truck so you can tune it. I know there are several UK owners on here.
 

Quickstop [UK]

Combating adversyty.
Re: Knocking

Really? Send them my way then!

I am downloading it as we speak. I should be able to get the cable fairly easily as well. There is so much good avice on here that it is sometimes hard to understand it all.

Where would you recommend I get the parts and bits I was suggesting? If I pay UK prices it will be extortionate.
 

JSM

Active member
Re: Knocking

tunerpro rt can be downloaded for free and uses the same cable.

FYI

def. files are on NWSTP
 

Quickstop [UK]

Combating adversyty.
Re: Knocking

ok,

got datamaster but need the cable. TTS do not make an OBD I cable anymore apparently. Where can I get hold of one?

cheers
 

AUSyTyIN

Unbusted $#it box
Re: Knocking

To find memebers in your area, try posting in the "SyTy's across the pond" or whatever it is called. Does anyone know of a UKSyTy?
 

Quickstop [UK]

Combating adversyty.
Re: Knocking

OK, will do.

Have ordered an OBD I cable from the US. Should be with me in about a week or so. Have got datamaster as well so that should help.

Where should I get info on what sparkplugs, leads, cap/rotor, fuel filter etc etc I can replace easily to minimise the knocking? I huess the main thing is the specs. We don't have GMC dealers here so I am reliant on you guys :)

Someone want to give me a big shopping list? ;)
 

AUSyTyIN

Unbusted $#it box
Re: Knocking

Most tune up parts are not purchased at any dealer. Replace the stock fuel pump with a Warlbro 255, the IC pump with a Sureflo (RV water pump), Conrad cap & rotor if you can find them, the best spark plug wires you can get local, and NGK UR5 plugs. Just use any quality fuel filter from you local parts store.
 
Top