lc1 program? low o2 volts

littleblackpsycho

Donating Member
Well I am really struggling with tunerpro and my wideband install. I finally got my truck to idle in the 13's afr. I couldn't get a stock 3 bar bin, so I used the 50 bin I have and got it to idle good at all instances, (in gear, park,etc) but haven't driven it yet. The first question I have is do you program both analogs on the lc1 to the 0-5 sweep or just analog 2 and if what do you program analog 1 to? Also my o2 volts are at 0 and when you hit the gas it goes to 4 but no higer. Is this possible. When my truck was at 10 afr the o2's where in the normal 900 range. Any help is appreciated. ( I am also trying to simulate the narrowband )
 

JSM

Active member
Re: lc1 program? low o2 volts

analog 1 becomes your stock o2 output, should be fine as sent from innovate
analog 2 is the wb, you need to reprogram to volts *2 + 10

F14 pin for analog 2, stock o2 signal pin for analog 1. Ground to ecm to avoid loops, etc.

That stock mV signal will be ~900 for anything over 14.7 just by nature and how it works. Hence why it is really not telling you much.
 
Top