Limits of the stock computer

Pittman

New member
If you run a PTE52, heads, cam, AA IC, exhaust are you still in the parameters fo the stock puter. I have the pte now and will do the heads & cam come end of summer. I will do this on a stock block for about 8 months until I get a new block up and going.

Do you need to go speed pro at this point?? IF you do, is there a lot to gain. It would be really coold if speedpro could operate on one of the new billy bad a$$ PDA'a they have now.
 

smeagol

Active member
It depends is the answer.

If you can burn chips, use a DIY wideband 02 and either datamaster/diacom... going to FAST/speedpro may not yield much.

If you do a big motor, and run a calibration not dialed in 100% for that buildup...you'll make some good gains going to an aftermarket computer that IS dialed in.

The Canadian boys are going that extra mile... they'll be datalogging a wideband 02, using the stock computer with modified injector drivers, 75# injectors, and a stout built motor. 10s should be possible.
 

Pittman

New member
Ok that looks pretty cool and in depth
How do you guys go about learning this, I have no one in my area that messes with the sy's so Im at a disadvantage on that. From what I see this can do is much as speed pro on my computer. I take it speed pro is a little better on the user end of it
 
Top