LIttle tuning help

TYHOGG

Active member
Finally got the typhoon runing half way decent, but i lost my old tune (batteries in the ostrich died). anyways i'm running pretty rich right now, but know how to adjust that. I'm getting the following codes:

12- Diagnostic test is working properly

14- coolant temp sensor signal voltage is low

15- coolant temp sensor signal voltage is high

21- throttle position sensor singal voltage is high during engine idle or deceleration

24- vechile speed sensor open or short circuit problems

43- electronic sprak timing circuit low voltage detected or circuit problems

I am using tuner pro 4 to tune. I do not run a thermostat since i live in florida and really don't need one. IS there any tuning paramaters i need to change? I think that will get rid of codes 14-15. I just replaced the dizzy to try and get rid of code 43, the truck runs was better with the new dizzy, but the plugs are really fouled from running so rich, would that cause the code 43? Codes 21 and 24 are new since i drove the truck around a little. Not sure what to make of those. Any help would be greatly appreciated guys i would love to get this back on the road.

Thank you,
Adam
 

The Bronze

New member
You will need to attach a datalog, or at minimum the voltages of the components in question.

Since the computer relies on inputs, it would be wise to remedy them prior to any further adjustments. Also, usually when many sensors are involved, it usually is a ground problem- tackle them first.
 

TYHOGG

Active member
Re: LIttle tuning help

I have double checked all grounds and verfied with my volt meter good continuity. I even added a few more grounds with some 4 gauge. These things are driving me nuts.
 

TYHOGG

Active member
Re: LIttle tuning help

Okay so while i was driving today the truck died 3 times. I pull over and let it sit for a while and it starts right back up. Can the code 43 cause this issue? I cannot figure out whats going on. I have replaced the ditributor twice and it does not help.
 

TYHOGG

Active member
Re: LIttle tuning help

after a little further investigation i'm going to try a new knock sensor and see where it gets me.
 

The Bronze

New member
Knock sensor? That isn't going to cause a no-start/die.

The hundred dollar question (what it would cost you at a shop) is: Did you still have spark when it would not start? The goal would be to determine ignition/fuel/ECM issues. With so many junk modules for sale, changing out the distributor doesn't proclude a bad module, although it can be many things. Did you have a CEL on when trying to restart it? Could you hear the fuel pump him when the key is turned to run?
 

Big Mike

New member
Re: LIttle tuning help

Any reason why you did not backup your tune to a memory stick/hard drive or a computer? Also may be a bad bin loaded on ostrich, re seat g1 pcb and stock chip also re seat cable from ostrich and look for bare spots on wires where they may have rubbed.
 

TYHOGG

Active member
Re: LIttle tuning help

thanks guys it was the msd box, finally crapped out after 12 years of use.
 
Top