Low boost question?

0-60N4

Member
Working on a Sy. Stock was running about 14 - 15 psi boost. Installed 3 bar chip and MAP sensor. Boost should have increased but did not. Installed manual boost control and no more boost. Disconnected pressure hose to wastegate actuator and still holds about the same. Does not build any more boost. No sign of leaks in turbo hose or boost to throttle body. Any ideas? Could the wastegate rod need to be adjusted (shortened)?
 

denny

Active member
Re: Low boost question?

You shouldn't see 14-15 with the wastegate disconnect, it should be around 8-10 on the stock wastegate.
To check the wastegate, pump some air into the port and see if the rod moves (a tire valve-stem, bicycle pump/air compressor and some vaccum lines). Can also disconnect it from the flipper and see if you can move the rod with a big pliers.
 

SBNova

New member
Re: Low boost question?

If your reading boost through the stock gauge, it wont be accurate after installing a 3-bar MAP. Not that they're very accurate any way, but the 3-bar will make it way off.
 

0-60N4

Member
Re: Low boost question?

I'm reading with a mechanical gauge and diacom with converstion chart for 3 Bar.
 

0-60N4

Member
Re: Low boost question?

Shortened the actuator rod about 4 turns and that got it where it needed to be.
 
Top