Low coolant light

JAY

Donating Member
Which sensor do I need to change to fix this problem? I know I have read posts that there are 2 coolant sensors.? Driving around town etc, it will not come on BUT when driving 2-4 hours the light will come on intermittently. I checked fluids and they were fine. Could it be the IC pump shutting off? Any info would be helpful. Thanks.
 

turbodog

Donating Member
IIRC, the IC 'low coolant' light circuit is not operational in any of our trucks. PAS screwed the pooch and failed to supply a ground path for the sensor. I have faint recollections that when folks in the past encountered this idiot lite coming on, it was related to a fuse or alternator problem. Try 'search'. but the discussions I'm recalling may be from the old email list days. Hopefully this will trigger a memory in someone else...
 

JAY

Donating Member
Need some help with overheating

Need some help with overheating

Again I am driving 120+ miles, low coolant light comes on, stop get gas etc, turn off, & it starts very hard after several attempts cranking. IC and radiator are hot but filled with coolant. I let the truck sit & idle thinking it would cool off but made the computer cut boost over 5 psi. After driving for an hour, 1/4 throttle, no coolant light, turned it off, let sit 15 minutes, disconnected & reinstalled ECM B fuse (on the right hand side), idle for 5 minutes to reprogram everything & everything's back to normal, full boost. Drive another hour and again same problem, sluggishness & hard starting. Let sit, disconnected B fuse, back to normal. What is the ECM A fuse on the left? Mine has a self resetting circuit breaker in it that gets hot after the truck has been driven. I started disconnecting this with the B fuse also. Is this the IC pump fuse, if not where is it? Where is the IC pump located? I didn't have this problem when I drove it 1400 miles from MI but now when driving 120+ miles.
 

skata

Donating Member
so how does that sensor work?
does it activate when the coolant is below the sensor level? in other words, completly empty?
 

turbodog

Donating Member
Re: Need some help with overheating

Re: Need some help with overheating

chargerman said:
What is the ECM A fuse on the left? Mine has a self resetting circuit breaker in it that gets hot after the truck has been driven.

Not in a position to look at my fuse panel, but I'm 99.999% sure that there should be a fuse in the ECM A spot, not a breaker. Sounds like a PO had a recurring problem and band-aided it with the circuit breaker. I'll try to check schematics. You should, too. look here:
http://www.syty.huryde.com/html/electrical/Wiring Diagram.pdf

I believe the IC pump may be on that circuit and the fuel pump as well. The injectors and (of course) the ECM. Any of these could be drawing excessive current, but the IC pump and fuel pump are prime suspects.
 

SY2455

70's Veteran
Re: Low coolant light

chargerman said:
Which sensor do I need to change to fix this problem? I know I have read posts that there are 2 coolant sensors.? Driving around town etc, it will not come on BUT when driving 2-4 hours the light will come on intermittently. I checked fluids and they were fine. Could it be the IC pump shutting off? Any info would be helpful. Thanks.

When I went on a test drive before buying my Syclone, I took it easy for about 4 Miles to let it warm up. Anyways when I got on it pretty hard getting on the freeway I-10 westbound the low coolant light came on & the truck die, the fuse blew that powers the IC pump, the ECM, etc. I finish the test drive by using the radio fuse to drive the truck, Later we found out the IC pump had burned up during the test drive. The guy replace it before I bought the truck.

Where is the IC pump located? If you are standing in the front of the truck with the hood open. look down at the water pump pulley & the crank pulley. Below the crank pulley, toward the bottom of the fan shroud, you will see a mini pump there. thats your IC pump.
 

JAY

Donating Member
Re: Low coolant light

Bringing up an old post but I'm still having this same problem. I just changed the coolant, fan clutch, radiator cap, thermostat & housing 180 degree.
http://www.syty.net/forums/showthread.php?t=29386
I have the Pitbull chip that utilizes the factory safety cutout. Has anyone ever looked to see that the return/suction/overflow line from the intercooler to the poverflow jug is always above the factory level of antifreeze in the "hot" position? I checked temps with a thermometer and even when the low coolant light is on, nothing is hotter than 180-195 degrees. As soon as the light is on= no boost and it runs very rough.
 

JAY

Donating Member
Re: Low coolant light

chargerman said:
Bringing up an old post but I'm still having this same problem. I just changed the coolant, fan clutch, radiator cap, thermostat & housing 180 degree.
http://www.syty.net/forums/showthread.php?t=29386
I have the Pitbull chip that utilizes the factory safety cutout. Has anyone ever looked to see that the return/suction/overflow line from the intercooler to the poverflow jug is always above the factory level of antifreeze in the "hot" position? I checked temps with a thermometer and even when the low coolant light is on, nothing is hotter than 180-195 degrees. As soon as the light is on= no boost and it runs very rough.
Does anyone have any suggestions?
 

NecroWolf

lost marbles member
Re: Low coolant light

for some reason my low coolant light comes on instead of my check engine light so you might look at that i know some others seem to have that problem too
 

JAY

Donating Member
Re: Low coolant light

UPDATE:
I recently purchased from the GM dealer the low turbo coolant sensor located on the heat exchanger. It was extremely wore down in size (I have pics of the new one next to the old) and was similar to a hot water heater heating element when you pull it out of a nonworking unit. It was surrounded by hard antifreeze/calcium deposits and was not even touching the coolant. I test ran it today and got it very hot and no problems.
 

JAY

Donating Member
Re: Low coolant light

Still having the same problem after the new pump & sensor.
 
Top