myclone
Donating Member
Ive been reading http://www.diy-efi.org/logo_gmecm.gif and http://www.diy-efi.org/logo_diy_efi.gif archives for sometime now and have a simple question(I think)...
When modding a ECM for p&h(low z) injectors is it just a matter of installed drivers for a TBI? Ive read/printed out a LOT of info but have yet to see someone give a explanation on what all needs to be done.
It looks to me like there is some other things that have to be done like larger zenors for the reverse EMF but I also read about changing some "jumper wires" or the like on the drive ckt.
Can someone poss elaborate on the subject a little?
TIA.
(oh, looks like a few ppl that are into this stuff that I recognized from this site have been at it for ~7+ years!!! Yeeeesh... I got a LONG way to go)
When modding a ECM for p&h(low z) injectors is it just a matter of installed drivers for a TBI? Ive read/printed out a LOT of info but have yet to see someone give a explanation on what all needs to be done.
It looks to me like there is some other things that have to be done like larger zenors for the reverse EMF but I also read about changing some "jumper wires" or the like on the drive ckt.
Can someone poss elaborate on the subject a little?
TIA.
(oh, looks like a few ppl that are into this stuff that I recognized from this site have been at it for ~7+ years!!! Yeeeesh... I got a LONG way to go)