Lower Ball Joint play

dgoodhue

BuSTeD 4.3
I failed inspection today for one of my ball joints, they are moog and have a little over 10k miles on them. I read through the service manual and the inspect tolerance is 1/8" or ~3mm. I would estimate that I have 1/2 mm, it definitely is less than 1mm, so I am definitely within spec.

The other side has practically zero play (I can't see or feel any play,) but the other side I can feel a slight looseness. From a realistic stand point, should I have no play in my ball joints. I do race my truck at the drag strip and I am hitting over 115mph in the traps.
 

dgoodhue

BuSTeD 4.3
Re: Lower Ball Joint play

I ended up calling moog, and the tech says that play is the ball joint wearing and it relative normal as the miles add up. He said a new one would have practically zero play like my other side.

During my conversation I explained to him that I do race with the vehicle and hit upwards of 120mph at the track. He response was 'I am showing that part number if a 4wd or AWD s-series truck. Do you have a Syclone or Typhoon?' My response yes I have a Syclone. He response, 'I figured that because no one really races the other vehicle applications I see on the list.' :rotf::rotf:
 

hatrik8

Donating Member
Re: Lower Ball Joint play

I ended up calling moog, and the tech says that play is the ball joint wearing and it relative normal as the miles add up. He said a new one would have practically zero play like my other side.

During my conversation I explained to him that I do race with the vehicle and hit upwards of 120mph at the track. He response was 'I am showing that part number if a 4wd or AWD s-series truck. Do you have a Syclone or Typhoon?' My response yes I have a Syclone. He response, 'I figured that because no one really races the other vehicle applications I see on the list.' :rotf::rotf:

:rotf:

Did you get him to send a new ball joint for free?
 

0966Sy

Code what?
Adding some grease could help minimize some play. Otherwise I would find another inspection facility
 

dgoodhue

BuSTeD 4.3
Re: Lower Ball Joint play

Adding some grease could help minimize some play. Otherwise I would find another inspection facility

MA inspection is strict on exhaust noise and I have had problems failing in the past. The exhaust technically can't be louder than stock. This place pass my exhaust. He told me that he has to strict on my truck because the exhaust is border line.
 

dgoodhue

BuSTeD 4.3
Re: Lower Ball Joint play

I lost the battle with inspection station, I am going just replace the ball joint.

I politely explained that I felt it was in spec, I brought the service manual with me to show him the spec and how it is tested. He brought out dial indication and said it failed, I went out to the shop to see the test setup and he didn't support the lower control arm and he was compressing my coilovers when he was lifting the wheel, which is how it failed. I point it that out and his explanation I can feel it and he doesn't feel that is pass. He said I could bring it to the inspection referee. I told him I understand and I would replace the ball joints. I kept it polite and friendly and he seem polite and friendly to me.

I definitely don't want burn this bridge or open the inspection referee can of worms. I might win the ball joints spec, but I might screw myself on my engine mods and the exhaust noise. I am not sure I want the MA inspection looking over my off road only JSM coilovers either.
 
Top