Lower intake & EGR port

TheObiJuan

Active member
jb weld works, others use plates. some use jb weld and mount the egr crap back on to make it pass visual inspection
 

Hu Ryde

Donating Member
So I should JB the lower intake! Should I put a rod, bolt or anything in it to help make it stronger?
 

Richme

New member
Re: Lower intake & EGR port

Hu Ryde said:
What have you done to plug this? JB weld? Tap? Other filler?

Here's a URL for plugging up the EGR, if that's what you are talking about.

HTH,
 

Hu Ryde

Donating Member
Thanks but I have that. I wanted to stop the EGR gas from getting into the intake thus keeping it cooler. Swede gave me a good pic of what I want to do. Thanks again!
 

Hu Ryde

Donating Member
plug.jpg
 

Sy769

Donating Member
That's exactly how I planned to block mine off. On my TPI camaro I fitted a piece of aluminum in the EGR port just below the intake gasket sealing surface. Filled the port with JB weld then pushed in the aluminum block. Stopped it as close to the source as possible.



Those of you who have removed or deactivated the EGRon a SyTy, how has this affected your gas mileage. I am curious how much actual loss in mileage compared to the benefits. Yes I know for good gas mileage don't drive a SyTy but I still would like to know is it 1MPG or 5MPG etc.
 

Hu Ryde

Donating Member
The more I look at the lower manifole the more I want to stop it there! I'll get some pics to show what I mean!
 

Hu Ryde

Donating Member
Here is my thoughts. The opening of the lower manifols for the EGR is a very skinny rectangle opening. Maybe a 3/8 opening by about 1 1/4 long. Maybe if I JB welded a piece of metal in there it would keep the heat from getting into the lower manifold at all this in turn would keep the upper that much cooler. In turn this would keep both my heads at the same temp because the driver side that the EGR draws from will have to keep all the EGR gass like the pass side does. Will JB hold up to the head and gases?
 
Top