Main caps and bearings

Pittman

New member
first off lets just make something clear "I am a complete dumbass" when it comes to anything below the heads. Im just trying to get all the right parts together to build a block.

I bought these

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=6770&item=2400612493&rd=1

they are 2.45 main caps that are stepped for a 2 bolt block.

PROBLEM When I took the old 2 bolt cap out of the block the inner dia doesnt match. The original measures 2.637 The new one is 2.570 with bearing removed. Do you have to have a machine shop remove the extra material and bore them? I dont know how you would bore half of something.
 

myclone

Donating Member
Yes they will have to be line bored. Copied pasted this from the sellers description:

"These are the Splayed main caps and do require a line bore for installation."
 

Sy769

Donating Member
Any time you change caps they must be line bored even if you replace it with a stock cap or mix up your originals.

They don't really bore half of it. They cut the cap if neccesary and then bolt it to the block and bore the mains in a fixture to the correct size.
 

Pittman

New member
yeah i guess my reall question is how that can accurately bore it if there is more material on one side than the other. Seems that will push your cutting tool to one side.

Im sorry I didnt clarify too much. Its more of a question for a machinest/engine builder. Ive done jsut enough work with a lathe and a mill to be dangerous. I would like to learn a little about how builders fit all of this together. Need a damn book really.
 

Pittman

New member
sy 769

Thats it. Thats kinda what I was wanting to know you must have been typing and positng the exact same time I was just then
 
Top