CarlzBowTy
Member
Hello everyone. My 92typhoon typhoon has hot
restart problem. Cranks fine hot but no start. I captured
It occurring using datamaster and noticed that the
ECM voltage was near 8-9 volts while cranking.
Is this to low for proper ecm operation? If I wait 5-10
Minutes ir fires right up.
I have an ostrich/moates setup with new stock ecm.
I am also considering using a remote relays to directly power
the ecm A and B bypassing the factory harness.
Thanks in advance for your replies.
restart problem. Cranks fine hot but no start. I captured
It occurring using datamaster and noticed that the
ECM voltage was near 8-9 volts while cranking.
Is this to low for proper ecm operation? If I wait 5-10
Minutes ir fires right up.
I have an ostrich/moates setup with new stock ecm.
I am also considering using a remote relays to directly power
the ecm A and B bypassing the factory harness.
Thanks in advance for your replies.