MIP/TIP ratios

vortecfiero

New member
I was reading a 3rd article (besides MAXIMUM BOOST) on Manifold Inlet Pressure versus Turbine Inlet Pessure. It was confirming the 1:2 max ratio and the ideal 1:1 or 1: (less than 1 ratio).

But enough about book learning. I was wondering if anyone has any experience, comments or theorys(?)

the search turned up nada
but i"m sure "someone who shall remain nameless" will jump in feet first j/k
 

Sy#26

New member
Only setup I measured exhaust backpressure on is my current TE60 / 14cm Mitsu combo. BP (pressure before turbine inlet) runs about 1.3x compressor outlet pressure. This was by two side by side gauges, eyeballed, not datalogged. I'd tried stock (8cm), 10cm and now the 14 - BP increases greatly on the smaller housings, to the point, on the 10, where boost was uncontrollable - WG would blow open w/ very little control from the WG actuator. Backpressure, WG size & restrictions in the signal line to the actuator are major determinants on spiking, creep (and sag), etc. Still working on this one - currently trying ECM controlled bleeder on a high pressure actuator - real spikey so far. Next will be a butterfly style WG in the stock housing - immune to BP.

FWIW, YMMV, etc.
 
Top