SBNova
New member
I just got an Autoprom. For anyone not familiar with it, go to Moates.net and check it out. Its like an Ostrich but it datalogs too, and is all USB. One cable from the autoprom to the laptop.
Anyway, I bought this because I got tired of messing with USB to serial adapters and really wanted to use my newer laptop with its nice big screen.
The autoprom has two modes; one is a passthrough or bypass where it will scan ALDL with nearly any software. The horizontal switch is set "away" from the USB port for this. I can connect just fine and scan the ALDL data no problems using TunerPro RT.
The other mode is "autoprom mode" where it will simultaneousy scan ALDL data AND emulate a chip all through one USB connection to the laptop. There are two cables from the autoprom, one to the ALDL and one to the ECM used in this mode. The horizontal switch must be set towards the left or towards the USB for this mode. I cannot connect in this mode to my Typhoon. When I do get "connected", there is no data, just errors like crazy.
I have posted about my problem at Thirdgen.org and Mangus (tunerpro creator) says there is a known problem connecting to SyTy ecm's running $58. He says its very difficult if not impossible to connect to one with the autoprom in "autoprom" mode.
HotRodV6 seems to be connecting and using his autoprom. Is anyone else having any luck with it?
You can read this post on thirdgen.org to see whats going on over there;
http://www.thirdgen.org/techboard/d...question-i-searched.html?posted=1#post2864126
Anyway, I bought this because I got tired of messing with USB to serial adapters and really wanted to use my newer laptop with its nice big screen.
The autoprom has two modes; one is a passthrough or bypass where it will scan ALDL with nearly any software. The horizontal switch is set "away" from the USB port for this. I can connect just fine and scan the ALDL data no problems using TunerPro RT.
The other mode is "autoprom mode" where it will simultaneousy scan ALDL data AND emulate a chip all through one USB connection to the laptop. There are two cables from the autoprom, one to the ALDL and one to the ECM used in this mode. The horizontal switch must be set towards the left or towards the USB for this mode. I cannot connect in this mode to my Typhoon. When I do get "connected", there is no data, just errors like crazy.
I have posted about my problem at Thirdgen.org and Mangus (tunerpro creator) says there is a known problem connecting to SyTy ecm's running $58. He says its very difficult if not impossible to connect to one with the autoprom in "autoprom" mode.
HotRodV6 seems to be connecting and using his autoprom. Is anyone else having any luck with it?
You can read this post on thirdgen.org to see whats going on over there;
http://www.thirdgen.org/techboard/d...question-i-searched.html?posted=1#post2864126