More ECM mods

jwaller

Evil Genius/SyTy Guru
I am wondering if anything can be done with the diagnostic connector thats inside the ECM case. :lol:

secondly if there would be any benifit to adding more SRAM to the open location on our ECM. :roll:
 

leroy

Donating Member
You could look at the diy-efi archives or ftp site for a project called lockers. It uses the edge card connector, but was developed for 165 baud ecm's, IIRC.

I don't know about the SRAM.

Jim
 

Fred Aldrich

New member
I trhink that the connector inside the ECM is used by GM to connect their Heads Up Display. Maps to the address space around $6000, the entry point of the software inside the HUD .
 

smeagol

Active member
Yep. I actually had one here for a short time... egads was that thing ancient. The capability exists for a trick setup where you'd be able to force values/changes in the tune while it's running connected to a laptop, but I don't foresee anyone making such a product... no return for the time invested really.

DirectScan for the Buicks uses the same type of hardware connection on the Buick ECM's. It is important for those cars as their ALDL data is S L O W, and the DirectScan frame rate is comparable to Diacom/Datamaster.
 

jwaller

Evil Genius/SyTy Guru
good info. thanks.. always wondered what that thing could be used for. but I guess we will never use it.
 

Sy#26

New member
Doesn't the HUD map to $5000?

Anybody know where the other memory map hardware addins are in our 7749s? Must be some RAM @ $0100-???? and elsewhere. Looks like the HC11 ADC & serial ports aren't used here either, but I could be *totally* wrong. Just starting to get into disassembly - got nuthin' else to do while waiting for engine to return from the builder......

Barry
 
Top