Need help w/chip ID,serious ping problem

GM tech

New member
Recently my Greddy Profec A boost controller went out,so I removed it and the MSD 6btm ignition and reinstalled the boost soleniod.Now it pings at the top of 3rd and O/D when on hills.My truck also has injectors,fuel pump,AFPR,KB cold air,KB upper intercooler and a chip.I've been having little drivability issues since I got it so I decided since the controller went out to go back to stock and go from there.The original owner installed all the mods and it appears it was done when the truck was pretty new.The shop I bought it from liensaled it after storing it for 4 years and has no info regarding the chip or other mods.I was hoping the chip was like the hypertech I put in my vette and just went between the orig and the ECM,it's not.I've never heard of this company before and was hoping someone has.
The label says:
Z-Industries,Inc. 1996 49 state
Typhoon-Syclone Custom
2500/9LB-Time A0EC EA731-R2
NOT C.A.R.B. LEGAL(big joke on me,bought and live in So CA.)
Is this an off the shelf chip or custom programmed?Is it any good?Should I replace it since I don't have the boost controller?How can I find out my injector size,I don't know the manufacturer?
 

SpoolingTurbo6

Donating Member
Re: Need help w/chip ID,serious ping problem

Could it be the torque converter chattering.does it do it with it unlocked aswell?
try using a lockup switch and see if it does it too
 

jwaller

Evil Genius/SyTy Guru
Re: Need help w/chip ID,serious ping problem

seen a lot of syty chips but haven't heard of Z industries. I suggest you check your timing and send that chip off to get reburnt with something known good and upgrade to 3 bar while your at it with some decent fuel injectors.
 

GM tech

New member
Re: Need help w/chip ID,serious ping problem

"Mech Tech" is who I bought my truck from,the owner liene saled it and sold it to me.
Anyone know more about this company,what I was told about my Ty when purchased doesn't match up with what I know now.My lower intake has been off(bought from M/T with 13053 miles) and I have been bothered by that since I bought it.Mostly bugs me because of the quality of the work,sealer everywhere,all brackets for my cooler missing,gaskets where they shouldn't be,etc.
 

SBNova

New member
Re: Need help w/chip ID,serious ping problem

Find someone with an eprom reader/burner and compare it to a known stock bin file. I could do it but I am accross the US from you- in Florida. Im sure someone closer would do it for you. You could send it to me but it will cause you some down time. If you get someone to read it please save it and post the results.
 
Top