Need HELP with wideband install

cvcsmkr

Donating Member
Okay ive been doing a bunch of research and i am now more confused than i was before.
i want to install My innovate LC-1 in place of my stock o2 sensor.
everyone keeps saying to use dig's patch. but from what understand there is a physical wiring patch and a software patch using his patcher.
I have datamaster and a ultimate chip. I have not done ANY tuning(other than fuel press/boost) nor know how too. All i want to do is log my afr and send my ultimate off to be tuned. I dont know how to use this patcher? I am completely confused and i guess stupid. Can someone please ellaborate on this very detailed.
thanks
 

Loeryder

New member
Re: Need HELP with wideband install

That patch has to be applied to a Bin file then burnt to a chip or run through an emulator.

Its considered a file level patch, not a hardware patch.

Contact Phil Long about burning you a new set of Bins for your Ultimate and you should be good.
 

93 TY 2185

Donating Member
Re: Need HELP with wideband install

cvcsmkr said:
Okay ive been doing a bunch of research and i am now more confused than i was before.
i want to install My innovate LC-1 in place of my stock o2 sensor.
everyone keeps saying to use dig's patch. but from what understand there is a physical wiring patch and a software patch using his patcher.
I have datamaster and a ultimate chip. I have not done ANY tuning(other than fuel press/boost) nor know how too. All i want to do is log my afr and send my ultimate off to be tuned. I dont know how to use this patcher? I am completely confused and i guess stupid. Can someone please ellaborate on this very detailed.
thanks

As said above the Software Dig wrote is for the chip patch.
You will also need to wire into your ECM or the harness the output of the LC-1.
This way the ECM will see the simulated NB and the WB will be shown in DataMaster.
Read this post for the infomation to do this modification.
http://www.syty.net/forums/showthread.php?t=20263&highlight=patch
 

JSM

Active member
Re: Need HELP with wideband install

A note you will also need to program the LC1 via the 9 pin.

I found a great article while searching when I got my LC-1

As mentioned Dig's patch must be applied to the chip, along with the WB information being fed in through F14 Pin.
 

Syclone Rob

Its all ABOOT the SYTY eh
Re: Need HELP with wideband install

I take it that digs patch you use for the lm-1 will work for the lc-1??
 

cvcsmkr

Donating Member
Re: Need HELP with wideband install

thanks for the info guys.
it seems there is a lot of people doing their own chipping, no one has mentioned that this has to be applied to the chip.
i didnt know if it was dm, the lc-1 programmer, etc.
anyways thanks for the help, and i will probably do a detailed write-up on the install for us newbs:)
 
Top