need help

J

john taylor

Guest
Had my '92 Typhoon for about a month and a half. The computer is giving intermittent code 33 and code 34 for a map sensor, and Ive gone through 5 or six of them. Finally I probed my sensor and put vacuum on it and it shows to be good. In field service mode just above zero boost I get open circuit. Symptoms on the motor are poor performance, rough engine, and hesitating building up boost (from a roll). Anyone with info that could help me get this thing going right would be greatly appreciated. 9 or 10 miles per gallon is burning a hole in my pocket.

John Taylor
Black Ty
66k original miles
 
B

Blake

Guest
If your MAP sensor is checking out OK do this.
Follow the wiring harness. Start at the MAP and work your way back. There is a multibracket that holds the EVRV and the MAP sensor. It has very sharp metal corners on it. The factory stretched the harness on most trucks very tightly around the bracket. If it cuts through the wires, the signal gets grounded out and voila, ecm sees "low voltage" from the MAP. You will have to disconnect it from the MAP and bend it the wrong way and you will probably find the cuts. If you leave it in it's "memory" position, you will not be able to see them. It is like a razor so it will be small. Just take some plastic wire loom stuff and wrap it so it protect the harness from any more cuts.
The reason I believe it is this is because your problem is intermittent and happens upon movt. JUST LIKE MINE DID. Funny thing how you'll remember every freakin problem you ever fix on these things. :roll:
Blake
 
B

Blake

Guest
Vac lines are most definitely a good check but his problem is intermittent. Intermittents tend to be electrical in nature. Sounds identical to what I went through. May not be it but it is a nice easy known problematic area to start. It just sounds so much like what happened to my Sy.
Just trying to help out.
 
Top