Need reducer from throttle boby to intake pipe

SY#2910

Banned
Who makes or can make a reducer from the throttle body 4 inch I am told to 2.5 inch turbo pipeing? I am running all 2.5" pipe and need to mate it up to the throttle body. Anyone have any idea for me?

Thank You !
 

Sy-1177

Turbo Inside
Re: Need reducer from throttle boby to intake pipe

SY#2910 said:
Who makes or can make a reducer from the throttle body 4 inch I am told to 2.5 inch turbo pipeing? I am running all 2.5" pipe and need to mate it up to the throttle body. Anyone have any idea for me?

Thank You !
The throttle body is actually 3.5". I had trouble finding one too for my Impala. You *might* be able to get away with the Home Depot rubber reducer for $7.95 but its a 4" at the big end and 3" at the small end and i'm not sure if you can get it to sit tight on the throttle body with a hose clamp. I'm guessing you're not running the stock IC anymore?
 

SY#2910

Banned
Re: Need reducer from throttle boby to intake pipe

Thanks guys. Yes I am doing the A/A set-up in a thread a little lower under engine tech. If its 3.5 then I can use a 3.5 to 2.5 silicone reducer and flaten out the pipe to match a little. I will put a string around it tonight and then measure the string and check. I sure hope its 3.5, it would make life that much easier. :p
 

Andreas

New member
Re: Need reducer from throttle boby to intake pipe

I used 4" - 3" silicone reducer on 2,5" pipes. On the pipe that goes in to the 3" end I put a shortie of 2,5" silicone hose and it match pertectly in the 3"
 
Top