new datamaster file

atc82

New member
I need the SyTy gods to look at my DM file.
I just installed the AFPR and Ian's vacuum hose kit. I don't have many mods, but the plugs are good, new ATR wires, PCVs are new, intercooler has heater hose replacement and aux cooler, timing has been set to 0*. About the only thing I haven't done in the SyTy Readme is the fuel pump and by the looks of the knock retard, that may be my problem. If anyone is interested I will e-mail the file. Thanks.
 

Hu Ryde

Donating Member
You have knock in both runs, your O2's are high so your not lean.....

_________________
Jesse A. MOFO#2
13.3 @99.41mph 1.7 60'
1.jpg

The venture into tranny land was fun but now over, at a fair price.
-Bottles are for babies, real men get blown!-

<font size=-1>[ This Message was edited by: Hu Ryde on 2002-03-24 23:02 ]</font>
 

jwaller

Evil Genius/SyTy Guru
the biggest standout I saw was low voltage. especially on the second blast. 12.5V isnt going to cut it. secondly the O2's were not that high on the second run either( in the begining) once knock starts its hard to stop. so an initial lean condition may continue to knock even though the O2s have come up since the start of the knock event. still the stock sensor is just a guide. what do you plugs look like? what chip is this? what gas are you running? what plugs ? what FP?
 

atc82

New member
On 2002-03-24 23:12, jwaller wrote:
the biggest standout I saw was low voltage. especially on the second blast. 12.5V isnt going to cut it. secondly the O2's were not that high on the second run either( in the begining) once knock starts its hard to stop. so an initial lean condition may continue to knock even though the O2s have come up since the start of the knock event. still the stock sensor is just a guide. what do you plugs look like? what chip is this? what gas are you running? what plugs ? what FP?

Haven't had a chance to pull plugs and take a look, it is the stock chip, gas was 92 octane, plugs are ac delco CR42TS, FP is 45 with line plugged. The cap and rotor are also new. I will clean the grounds, but first I need to know where they are? If that doesn't help, what esle could help the volts? new alternator?
 

sy2185

New member
Had the same problem- down as low as 12.7 on some WOT runs w/DM. Just friday put in a new optima red top and never got below 13.1 at the track Sat.
Jeremy
 

Falco

Donating Member
Aaron,

Before you start to replace your alternator, you should check the actual voltage with a Digital Volt Meter. Hook up two cables, one to the back of the alternator, the second to a ground nearby and check your voltage at WOT. It should be above 13v. If it's not and the ground clearing can't help than you can start to think to replace something. Beside the alternator it could be a bad battery too, check it too.

If you can see appropriate voltage at the DVM, but not in Datamaster, than you should check the following thread.
http://www.syty.net/phpBB/viewtopic.php?topic=9031&forum=3

Either this or a different ECM. The voltage showed up in DM varies from ECM to ECM.

HTH,
 
Top