New motor start-up q's

tealty

New member
Guys,

I was out working on my project blazer with the syclone motor in it. I bought the motor a few months back from someone from canada and he bought it from someone else whom I can't get ahold of. I pulled off the stock exhaust manifolds, in order to install the ATR headers. Well, there is fresh porting in the exhaust ports and NO carbon buildup. Should I just put oil/gas in it and fire it up, or should I treat it like its never been fired up before? I think i'm going with the latter just to be safe. What are your suggestions to firing up a motor for the first time?
THanks
Jordan
 

Mkid

New member
OOOYeah,

Thats going to be fun i just put a fresh Typhoon motor in my blazer. You need to oil prime the motor to get the oil throught the engine then start it up & let it run for like 30 sec. to a minute then change the oil. then start it up again and let it get up to temp then change the oil again.And after that test drive it AND CHECK FOR LEEKS very carefully also watch the oil pressure!

It probably won't start with the blazer fuel pump unless you changed it and all the fuel lines to high pressure line.Also you'll need a 20 amp fues to run the pump.

good luck,

malik
 

tealty

New member
Thanks Malik. How do I prime the oil pump? I know that I need to start it with regular dino oil too right. Oh, No worries on the fueling, I have a fuel cell with external fp and 6an steel braided lines running to the motor.
Thanks,
Jordan
 

just a 6

R.I.P MyClone
Well if he has a new cam he need to let it run on 2000 rpm for about 20 minutes before he shut it down. That is to break in the cam lobs, other wise they wont last long :smile:


On 2002-01-20 14:55, Mkid wrote:


OOOYeah,
You need to oil prime the motor to get the oil throught the engine then start it up & let it run for like 30 sec. to a minute then change the oil. then start it up again and let it get up to temp then change the oil again.And after that test drive it AND CHECK FOR LEEKS very carefully also watch the oil pressure!

It probably won't start with the blazer fuel pump unless you changed it and all the fuel lines to high pressure line.Also you'll need a 20 amp fues to run the pump.

good luck,

malik
 

V6 Kompressor

New member
If it is a roller cammed engine, break-in shouldn't be a problem there, but, befor you put the distributor in, you should prime the engine w/ oil with an oil primer via a drill (electric or pneumatic). Have the valve cover's off and make sure that oil is coming out of the oil holes on the rocker arms, while running the priming device. I would find somebody that is experienced to be there with me if you haven't started up a new engine before, especially to help with the gauge watching, timing setting ect...
 

tealty

New member
Cool, thanks guys....Christian i'll call ya. Man I wish I could get ahold of the other owner to see if it was really totally rebuilt and what it has internally.
Thanks
Jordan
 

V6 Kompressor

New member
Sorry swede, didn't mean to flame a little, but that was a good instruction that is spelled out on the camshaft break-in cards of non-roller camshafts. Tealty, you might really try to find out what's inside the engine you bought from the builder...
 

tealty

New member
Well, I removed the valve cover today and found white grease where the pushrods seat into the rockers. So its confirmed.
later
jordan
 
Top