New to Datamaster

gstacky

Member
So I have my datamaster up and running, no problems there reading the truck. But I really don't know what exactly I am looking for. I have taken it up and down the road a few times while monitoring just to see what I am getting for readings, but have to do some recording now that I think I have it figured out. What should the knock levels be? Keep in mind this is basically a bone stock truck, and I just want to make sure it's running right before I start enjoying it. Any help would be appreciated.

On a side note, I haven't hit WOT yet, but under some heavier acceleration, there is some kind of a whistling or whining noise, definitely not detonation, I have heard that before, but this noise is new. Any ideas.
 

WyoSyclone

Active member
Re: New to Datamaster

So I have my datamaster up and running, no problems there reading the truck. But I really don't know what exactly I am looking for. I have taken it up and down the road a few times while monitoring just to see what I am getting for readings, but have to do some recording now that I think I have it figured out. What should the knock levels be? Keep in mind this is basically a bone stock truck, and I just want to make sure it's running right before I start enjoying it. Any help would be appreciated.

On a side note, I haven't hit WOT yet, but under some heavier acceleration, there is some kind of a whistling or whining noise, definitely not detonation, I have heard that before, but this noise is new. Any ideas.

Look for "0" KR, approximately 14.7 afr at idle and cruise, approx 11.2-11.5 afr at wot, take a look at how much 'spark advance' you're running at different rpm/boost levels, look at your IAT temps.

If you get up to WOT look at your injector DC values. Look at the ignition voltage up at the top of the screen. See if you have any DTC's. How are the engine temps?

Sitting with the engine off and DM running in monitor mode check to make sure you get 100% TPS when you fully depress the accelerator pedal.

About that whistle.... take off the intake crossover tube (from airbox to turbo) and make sure it hasn't cracked with a piece about ready to flake off and screw up your turbo!
 

gstacky

Member
Re: New to Datamaster

Thanks for the response, I'll look into those and see what I'm getting. As for the intake tube, I looked it over really well before putting it back on, and it was perfect, but just to be sure I'll check it again.
 
Top