NEWB needs a little help

turbodig

Active member
Re: NEWB needs a little help

F29

kPa range - 40-70
RPM range - 800-1200

Bump value 2 pts at a time and verify WB readings. Doing this while emulating makes it easy.

My advice is to set idle rpm (3 tables - F13, F18, F19 - Batt Volt, Idle in gear, Idle in P/N, respectively) to desired rpm.....iron out timing in F1, F2, F3 (F1 is usually the one that needs the most work).....then start working out the fueling. Remember to check for any nasty fueling transitions that might occur when going from P/N to D (with lights on, A/C on, wheel turn full lock, etc....). Put it under a heavy load, shift into D, and make sure the AFRs look good with no stalling. If stalling or heavy stumble, work on F29. If problems occur when going from D to P/N, work on F29C.

Idle is easy, but teaches you tons how the truck reacts to tune changes.....which will be VERY helpful later on.

The above would be true for $58, but most of the code59 guys don't use F29c. (ie, it's disabled)

I would agree, though - start from the driveway, and work your way out, as far as tuning goes. Most guys wanna jump right to WOT, but end up changing everything once they start doing idle, part throttle.
 

sytyguy

Moderated User
Re: NEWB needs a little help

The above would be true for $58, but most of the code59 guys don't use F29c. (ie, it's disabled)

I would agree, though - start from the driveway, and work your way out, as far as tuning goes. Most guys wanna jump right to WOT, but end up changing everything once they start doing idle, part throttle.
:doh:- Do'h.....forgot we were dealing with $59. I've been doing so many stock bins lately, I'm back to $58 thinking.
 

Mario65

Hotrodicus Supersonicus
Re: NEWB needs a little help

I am happy for today. I have it idling nearly the same afr around 14 in Pand D. I am sure someone like yourselves could really dial it in. Right now its pretty nice for a dip like myself. I adjusted all the RPMs in the three things you said to get even. They were little off. It turned out pretty good. I didnt have to touch F29 thank God.
It needs some finishing at shindig which I am sure will happen.
I got the ALDL cable connected and the Ostrich emulating and made some changes. That was my goal and its done.
I think I should wait until Shindig to upload my bin to Code 59.org.since I am sure its good but not great.
Happy to pass it on if anyone wants it.

One Q though why does my AFR show up as 10 constant in tunerpro and my scanner but the guage reads normal?


thanks again everyone
 
Top