Oil pressure switch possible leak???

Mario65

Hotrodicus Supersonicus
I have been hunting down one last leak on the TY. I was looking around the distributor and the oil pressure switch is back there loosely spinning in the block. I can move it left and right. Cant be sealed? Any ideas on how to make sure its done right? Should I take the switch off and unscrew it and then put something on the threads to seal it and reinstall the the switch? Never touched one back there before.

thanks
 

4C FED

Absolutum Dominium
Re: Oil pressure switch possible leak???

Most likely it has been over-torqued.
You could remove the sender & try tightening the nipple another turn & see how it feels.
 

Mario65

Hotrodicus Supersonicus
Re: Oil pressure switch possible leak???

Most likely it has been over-torqued.
You could remove the sender & try tightening the nipple another turn & see how it feels.

If its loose think its a leak?

IF I cant get it to tighten firmly to the spot I need it point towards what do you think I should put on it? I have some "the right stuff", etc.
 

4C FED

Absolutum Dominium
Re: Oil pressure switch possible leak???

If its loose think its a leak?

IF I cant get it to tighten firmly to the spot I need it point towards what do you think I should put on it? I have some "the right stuff", etc.
Definitely it will leak if its loose.

Not sure what you'd use. Whatever it is you're going to have to get it super clean & dry to get anything to work worth a darn.
 

Mario65

Hotrodicus Supersonicus
Re: Oil pressure switch possible leak???

Definitely it will leak if its loose.

Not sure what you'd use. Whatever it is you're going to have to get it super clean & dry to get anything to work worth a darn.

Yea that what I am thinking. Id rather have something that will lock it down like a loctite and yet seal it also.

I talked to permatex yesterday and the guy said use acetone to clean before using a sealant or silicone.
 

Don W.

Stab it and steer it
Re: Oil pressure switch possible leak???

If you remove the dist it's a piece of cake. If you remove the upper intake THEN the dist it's really a piece of cake.:lol: The sender screws into what you might call a tall brass elbow that is, in turn, screwed into the block. Both should be tight. Based on your description that fitting is loose. Remove the sender and the fitting. In this particular case I'd recommend loctite on the fitting where it screws into the block, NOT any kind of Teflon sealer.

Of course it's possible the sender is leaking also.
 

Mario65

Hotrodicus Supersonicus
Re: Oil pressure switch possible leak???

If you remove the dist it's a piece of cake. If you remove the upper intake THEN the dist it's really a piece of cake.:lol: The sender screws into what you might call a tall brass elbow that is, in turn, screwed into the block. Both should be tight. Based on your description that fitting is loose. Remove the sender and the fitting. In this particular case I'd recommend loctite on the fitting where it screws into the block, NOT any kind of Teflon sealer.

Of course it's possible the sender is leaking also.

Your right on the money.
I took off the drivers valve cover gasket and it was easy to get to. I just didnt have a 1 1/16 wrench or it would have gone much easier. Everything is off and I have cleaned it with acetone. I dont think I can get it to tighten to a nice snug fit without it pointing in a direction I dont want. I think I will go with loctite blue on the brass fitting to the block and just tighten the sender. The sender was on there tight. It was the fitting into the block that I could move around easy and was wet around the base.

thanks
 
Top