Passing Emissions??

NeedaSY

Go Ahead N Go
Will my truck pass emisions with my ultimate chip set on valet mode cause i wont be the one driving there??
 

QUICK STORM

B.A.M.F. BMW Tech
Re: Passing Emissions??

NeedaSY said:
Will my truck pass emisions with my ultimate chip set on valet mode cause i wont be the one driving there??

i would suggest you be there, but turn FP down to 40psi with the vacuum line disconnected and make sure you have had a recent tune up. do you have a cat on the truck?
 

NeedaSY

Go Ahead N Go
Re: Passing Emissions??

the people there where saying i need a new cat i have one to switch witch but if i turn the fuel pressure down will i pass anyways
 

Try Me

New member
Re: Passing Emissions??

Not to highjack the thread, but Here in Maryland you can get special tags (Street Rod or Historic cant remember which) if your vehicle is limited production. I think it has to be 20 years old, but we are getting close to that. Im looking into it and plan on "limping" myself throught the next couple tests until 2011. You might want to check to see if your state has something similar

Also, do they do treadmill tests out there? The do here but wont run my truck because of the awd. they have a awd treadmill but never use it dont know if anyone there knows how. I just get a tailpipe sniffer which i have passed without a cat or any other piece of emissions equipment...
 

sleepy

Member
Re: Passing Emissions??

With the fuel pressure down in the normal range - I would try and take it through on valet mode, or 115. Thes both should work as long as your cat works.
Also MAKE SURE TO TELL THE TEST LANE PEOPLE IT'S AWD. If there is a dyno test, they will try and run it on the dyno and mess things up.
 

NeedaSY

Go Ahead N Go
Re: Passing Emissions??

yea i failed 2 times already and i pulled into the awd side and they didnt say anything but ask me if it was. Whats normal range and how can i do this without a fuel pressue gauge??
 

tippmann243

New member
Re: Passing Emissions??

in st louis they do do the tread mill test, and i talked to a local sy guy once and he saidhe faild horible turned the FP down and disconnecte dhte vac line (im guessing is a rising rate FPR?) and then he passed fine
 
Top