Plug gapping????

sy112

New member
Ok, I know what the plugs are supposed to be gapped at, and I think I have a pretty good idea what they should be gapped at when running the water/alky setup. Or at least what to start tuning at. My question is how bad, if I am running let's say 28-30 on the plugs, would it be on the motor and what effects could I see.

Cause I plan on running the alcohol pretty much all the time, but I would also like to be able to turn it off and drive it if I am going on a trip and don't need the alcohol or just to see what it is running like without me spraying. Want to make sure I am not relying on the alcohol for anti-knock, just for the performance piece of it.

Basically I am asking if I am running 20 lbs of boost spraying with the gap at 28, then I turn the alky off and turn the boost down to 15 lbs, do I have to regap the plugs to prevent damage?

TIA
 

leroy

Donating Member
Don,

You won't hurt anything. Idle quality may not be quite as good with a narrower gap.

Generally, a narrower gap is used for higher boost pressures. The higher boost means higher cylinder pressures, and misfires are more frequent with a wider gap and higher cylinder pressures.

I'm not aware of any reason why alcohol, by itself, would require a narrower gap. A lot of alcohol might make a rich mixture, and be more subject to misfire with a normal gap.

Maybe Buster can add to this. I know he upgraded his ignition to run lots of alcohol. I'm not sure of all his particulars.

Jim
 

sy112

New member
Thanks Jim

It seems I read a post when I was trolling about where someone recommended narrowing the gap for running a water/alky/meth injction. seemed like 28 was "recommended". I am running a lot higher boost. Going to turn it back down to 17lbs until I get the whole tuning alky thing figured out. Then try to get it back up to 20 or so.

Finally rerouted the wiring for the SMC, should have no more problems with my TurboLink not wanting to record when the pump turns on. Can't wait till tomorrow to go see, all this damn rain put a damper on my tuning afternoon :cry:
 

leroy

Donating Member
Don,

I know you have a few projects coming up, so let me know if you need some help.

Jim
 

Buster

New member
I'm running ur6ix, gap is set between .035-.040, basically I didn't touch 'em. When I was running the stock ignition I had my gap set really tight, I think I was down to like .028 before I finally gave in and went with the MSD Stuff.
 
Top