Polished Cobra elbows
- Thread starter syty9933
- Start date
It's just a six
Super Member
Re: Polished Cobra elbows
Can you chrome plate rubber?
http://intakehoses.com/Merchant2/merchant.mvc?Screen=CTGY&Category_Code=CHEW
Can you chrome plate rubber?
http://intakehoses.com/Merchant2/merchant.mvc?Screen=CTGY&Category_Code=CHEW
Z SKI
Donating Member
Re: Polished Cobra elbows
Turbonetics used to sell a cast aluminum 3" tight radius 90* (cobra), check them out.
See ya,
Turbonetics used to sell a cast aluminum 3" tight radius 90* (cobra), check them out.
See ya,
It's just a six
Super Member
It's just a six
Super Member
Re: Polished Cobra elbows
That's a cobra elbow?
these are sweet a lil pricey but they are neat looking
thanks dewd
That's a cobra elbow?
Re: Polished Cobra elbows
i looked on the site but saw nothing, so i typed in (turbonetics cast allumnuim 3) and i came up with a bunch of stuff, i also bought the black silicone connectors, they can be used for intercooler piping or for turbos
i looked on the site but saw nothing, so i typed in (turbonetics cast allumnuim 3) and i came up with a bunch of stuff, i also bought the black silicone connectors, they can be used for intercooler piping or for turbos
Z SKI
Donating Member
Re: Polished Cobra elbows
I don't think they were, its in one of the older catalogs I have
Nope, that's not it. Ill see if I can find a pic of it
I don't think they were, its in one of the older catalogs I have
Nope, that's not it. Ill see if I can find a pic of it
BoostedSUV
Active member
Re: Polished Cobra elbows
I got mine from RPM... It's not polished or chromed though, its rubber?
I got mine from RPM... It's not polished or chromed though, its rubber?
It's just a six
Super Member
Re: Polished Cobra elbows
I was just curious, because I do not remember seeing one in there catalogs,but I could be wrong.
Brain fart?
I was just curious, because I do not remember seeing one in there catalogs,but I could be wrong.
Brain fart?
ghettosled
SYTY SUPERSTORE
Re: Polished Cobra elbows
you can always weld a v band assembly to the compressor housing and then weld the other side to a tight radius bend? using an aluminum bend with a rubber coupler and t bolt clamp would be a tight fit regardless of the radius. it would sit too close to the radiator. the v band would allow for a tighter fit. this is only if you have to have a metal pipe and not a rubber inlet.
you can always weld a v band assembly to the compressor housing and then weld the other side to a tight radius bend? using an aluminum bend with a rubber coupler and t bolt clamp would be a tight fit regardless of the radius. it would sit too close to the radiator. the v band would allow for a tighter fit. this is only if you have to have a metal pipe and not a rubber inlet.