Dr.Evil
Addicted to Boost
today I got around to installing the V9 Ultimate that came with the truck. I hooked everything up including the 3 Bar MAP and fired it up. It poofed a bit more smoke than ususal, but seemed to run fine. I set it to T115 and took it for a spin. I gave it a little gas and it stumbled, sputtered and fell on its face.
I tried putting the 2Bar sensor back on and it didn't idle at all. I took that off and and fired it up. It acted just like it did with the 3Bar hooked up. I have a feeling the 3bar is broken.
We took resistance readings of the 3bar and got the following:
A B C
A - 9.3K 3.8K
B - - 5.4K
C - - -
Are these numbers okay? I'm hopeing that the sensor is bad and not someone else. Could someone verify these #'s for me?
Also, does the ultimate require a high-flow fuel pump and FPR? I have these but havent installed them yet. I just wanted to get the chip up and running.
Any help would be great.
I tried putting the 2Bar sensor back on and it didn't idle at all. I took that off and and fired it up. It acted just like it did with the 3Bar hooked up. I have a feeling the 3bar is broken.
We took resistance readings of the 3bar and got the following:
A B C
A - 9.3K 3.8K
B - - 5.4K
C - - -
Are these numbers okay? I'm hopeing that the sensor is bad and not someone else. Could someone verify these #'s for me?
Also, does the ultimate require a high-flow fuel pump and FPR? I have these but havent installed them yet. I just wanted to get the chip up and running.
Any help would be great.