PTE boost control

E-Rue

New member
i think that a lot of you people dont get it.

i didnt get it totally untill just recently.
had to have a WB O2 to fully digest it into my little brain.

1. PTE wastgate has a 15psi actuator.
2. you SHOULD get 15psi at WOT.
3. if you dont get 15psi at WOT then you are running rich, need some more timing, or have a restrictive exhaust.
4. if you have wavy or wandering boost, its because your fueling curve is waving and wandering.
5. you dont need a boost controller to get a rock solid 15psi. you need a WB and some tuning skilz.
6. the more you tune the better your boost control will get.
7. do nat have sex with barnyard animals cause it will not help boost control

e

abh.jpg
 

myclone

Donating Member
Cool...

7. do nat have sex with barnyard animals cause it will not help boost control

I dont wanna know how you found that out. :eek: :eek:

Why do you have all the even # plug wires going to youre AC delete pulley? IMO 3 extra spark plugs installed there wont help either. :-?

What'd you come up with for a nice round number on max injector duty cycle you asked about in the other thread? Every thing Ive read kinda leans to around 80% max and if you get to 90% you should go with bigger injectors. Dunno how accurate that is but that seems to be the general idea I see when poking around on diff sites on the net.
 

Buster

New member
Do you guys know if the duty cycle displayed in datamaster is accurate? I seen 115% when I was down in Iowa racing last year.
 

Daron

Active member
Not sure about the PTE setup, but start going lean and boost control will get wacky with the stocker. Ok, maybe more wacky than normal..
 

E-Rue

New member
im higher than a giraff ass.

i think the ECM/datamaster can command/read any duty cycle it wants to, but anything over %100 is just static.

e
 

smeagol

Active member
Buster said:
Do you guys know if the duty cycle displayed in datamaster is accurate? I seen 115% when I was down in Iowa racing last year.

you are referring to wastegate duty cycle?!
 

smeagol

Active member
Buster said:
smeagol said:
Buster said:
Do you guys know if the duty cycle displayed in datamaster is accurate? I seen 115% when I was down in Iowa racing last year.

you are referring to wastegate duty cycle?!

Injector. I was responding to myclone post.

just saw that

the way i understand it, the duty cycle is a calculated value by datamaster.. it takes the commanded pw, and calculates duty cycle via RPM. it shows the mathematically correct value, so anything over 100% is static. i can't speak to its accuracy, but everything i've seen so far points that it is correct. i see a LOT of runs with > 100% DC on stock injectors, haven't seen much with high DC on bigger injectors.
 
Top