PTE63 and 2800 9/11

Buster

New member
I've got a 2800 9/11 sitting here and I'm wondering if it'll work with the PTE63 & stokes cam? What stall did BG run in his Sy?
 
G

Guest

Guest
SS;

I believe BG was running 3000-3200 stall. I'm running the above mentioned with .85 TH, with a 4k stall and it works great! Boost comes in about 3200 on my motor. If you have smaller turbine housing (.65) you'll be fine. If you have .85 TH, it "may" be a lil sluggish on the low end. You will be close tho...... besides, depending upon state of tune, you may be making enough HP that stall will be higher than stated. Mine was rated as being 3200 stall........ HTH,
 

smeagol

Active member
Mine was a 9-11 custom spec'd out. I saw ~3500RPM stall w/4 psi on the line. Leave with any less rpm or boost and it was a bit slow. Leave with any more and it would head towards the stands :wink:

Brian G
 
hey brian
note about "headin for the stands" - as of today, after consultation with edelbrock, i lightly modified and installed a set of shocks (front) meant for a fullsize 4wd gm ute of some sort - i forget the app.
i had, previously, fresh edel shocks all the way round.
front end jump on acceleration is now literally cut by over 60%, i would say...ride's a bit rougher, but tolerable.
lmk via email if u wants part #'s and procedures.
 
hey brian
note about "headin for the stands" - as of today, after consultation with edelbrock, i lightly modified and installed a set of shocks (front) meant for a fullsize 4wd gm ute of some sort - i forget the app.
i had, previously, fresh edel shocks all the way round.
front end jump on acceleration is now literally cut by over 60%, i would say...ride's a bit rougher, but tolerable.
lmk via email if u wants part #'s and procedures.
 
Top