Pulse width

kwick6

Donating Member
Can you look at your pulse width and make the determination that you are out of inj, and it is necessary that you upgrade?

I thought the inj pulse width should look something like this.

60/RPM...
So at 4000rpm, 60/4000=.015 or 15ms PW
3500rpm, 60/3500=.017 or 17ms PW

Anything over 15ms @ 4000 rpm you have ran out of injector.
And anything over 17ms @ 3500 your out of inj.

Say you see you have a PW of 12ms at 4000rpm, so 12ms/15ms=.8 or 80% duty cycle.

Is this correct?


TIA,
Scott
 

smeagol

Active member
The math is correct I believe.

Remember that most of the cals out there run the injectors static. What you can alter is the fuel pressure.

If you are running a high base fuel pressure, and you are running static injectors, and still going lean, yes you need bigger injectors.
 

kwick6

Donating Member
Can running them static cause them to wear out?
I mean, with the increased operation of them.

I would think it might be possible that you can lose some of the efficiency over time.
That maybe one might start to become slower or not as responsive, and you might not notice it amongst the rest.

I know anything is possible, but its important to know if every possibility has been covered when pushing these trucks into higher boost, performance, and maintenance.

Thanks,
Scott
 

smeagol

Active member
Well I can't see it being GOOD for their operation, but I don't think it will damage them really. Almost all the Syty's run the cal at static at some point, most from the factory will as far as I know.

I don't see Syty injectors failing left and right...
 
Top