questions about intercooler endtanks

KGB Pilot125

New member
here is my intercooler:

221fmic.jpg


I would like to ditch the cast endtanks and use sheetmetal endtanks, anybody have a good source for these or am I gonna have to do it my self?any help would be appriciated. its a 2-115 it is 18" wide, 6"tall, 3.5" thick. oh and its a spearco. I dont think that there is any perfomance other than weight this thing is a heavy ass pig. and I dont want to hang this much weight out over the front end!
 

jwaller

Evil Genius/SyTy Guru
corky bell has a major how-to on design and placement of end tanks. may wanna look that up
 

BigAl...

Member
KGB before you start this little project STOP don't waste the time or the money, it's just not worth it. You probably won't loose more than a pound or two at the most! IMHO that's just not worth it! Use aluminum tubing instead of mild steel and you'll probably save more weight. As a matter of fact most of the weight is in the core, I know this because I used a similar Spearco TYPE core.

just my .02 worth 8)
BigAl...
 

KGB Pilot125

New member
jwaller said:
corky bell has a major how-to on design and placement of end tanks. may wanna look that up

i was reading that last night and that confirmed the fact that I want to cut them anyways to put in a baffle to redirect air coming in. corky says that the top to bottom is the best because less pressure loss and such.

big al I am going to most likely use stainless piping. already have aluminium but its not bent how i want it. I really thing that the entanks will save a few pounds this the heaviest intercooler I have ever picked up it weighs around 40-50 pounds
 
Top