atomicmecha
I hate rust
What size balancer is recommended for our motors? And we use ones for external balanced motors right? Looking for a good balacer while also not breaking the bank.
quick balancer question
- Thread starter atomicmecha
- Start date
Davemc1963
93 Ty Owner
Re: quick balancer question
Neutral balance.
Try Rockauto, search under Syclone or 92 Ty. Dont search under 93 Typhoon, always brings up incorrect info on most sites.
http://www.rockauto.com/en/catalog/
Neutral balance.
Try Rockauto, search under Syclone or 92 Ty. Dont search under 93 Typhoon, always brings up incorrect info on most sites.
http://www.rockauto.com/en/catalog/
Cronic fatigue
toe cutter
Re: quick balancer question
Pioneer- 872021, $140
Pioneer- 872021, $140
atomicmecha
I hate rust
Re: quick balancer question
Thoughts on this one?
http://www.ebay.com/itm/351387173960?_trksid=p2060353.m1438.l2649&ssPageName=STRK:MEBIDX:IT
Thoughts on this one?
http://www.ebay.com/itm/351387173960?_trksid=p2060353.m1438.l2649&ssPageName=STRK:MEBIDX:IT
Davemc1963
93 Ty Owner
Re: quick balancer question
Re the link to Rockauto above. They currently list among others, a PIONEER DA2621 for a shade under $63, you'll always also find a discount code to save a couple $ somewhere on line.
I believe but will always stand to be corrected on this though, is that one issue with using a sbc balancer is that the timing marks on the timing cover are usually different to the 4.3, so tdc dosent align with the timing mark.
As long as what you choose is the same outside diameter, neutral balanced, clears the timing cover and you can align/shim the crank drive belt pulley with the rest of your set up it should work. You will just need to determine where tdc is and mark it on the outer ring.
Re the link to Rockauto above. They currently list among others, a PIONEER DA2621 for a shade under $63, you'll always also find a discount code to save a couple $ somewhere on line.
I believe but will always stand to be corrected on this though, is that one issue with using a sbc balancer is that the timing marks on the timing cover are usually different to the 4.3, so tdc dosent align with the timing mark.
As long as what you choose is the same outside diameter, neutral balanced, clears the timing cover and you can align/shim the crank drive belt pulley with the rest of your set up it should work. You will just need to determine where tdc is and mark it on the outer ring.