SYO237
SyTy Registry
my method of removing the cat from DP:
basically using a cutting wheel and carefully making a nice clean 2" cut that was deep enough to go through the cat, but not into the DP. I went slow.
I then used a flathead screwdriver and wedged it into the cut and opened up the end of the cat. basically, I flared the end.
Few hits with a mallet and it came off.
Of course, I didnt intend to reuse my cat, but it could easily be welded back into the proper shape if needed.
basically using a cutting wheel and carefully making a nice clean 2" cut that was deep enough to go through the cat, but not into the DP. I went slow.
I then used a flathead screwdriver and wedged it into the cut and opened up the end of the cat. basically, I flared the end.
Few hits with a mallet and it came off.
Of course, I didnt intend to reuse my cat, but it could easily be welded back into the proper shape if needed.